Abstract:Background: The electromagnetic aircraft launch system helps the carrier aircraft accelerate take-off on a short distance on the flight deck. Linear motors are required to have high efficiency and thrust / volume ratio, as the actuator of the EMALS. In addition, linear motors were required to have the fluctuation of the thrust is as small as possible to prevent impact and overstress on the airborne equipment. The thrust performance and thrust fluctuation suppression of linear motors are the current research hotspots in the field of EMALS. Objective: This paper proposes a multi-segment LPMSM to improve the efficiency of the system. Methods: We design a decentralized primary structure based on the Autonomous Decentralized System (ADS) concept. Only the coils near the moving secondary are motivated during the launch process. The others could be released from being driven after the secondary slide over; this control will save energy. Results: A multi-segment linear motor is proposed to improve the efficiency of the EMALS. This motor consists of two sections - the one with iron core for the low speed process and the one without iron core for the high speed process. Conclusion: The normal direction component of the air gap magnetic flux density is much larger than that of the longitudinal component, and their values are 80-90% and 10-20% respectively. For the normal direction component, it is mainly affected by the third, seventh, and ninth harmonics. The accelerating and energy test results show that, in the accelerating process, the efficiency of the linear motor can be more than 90%, and the acceleration is stable.

Magnetic-Thermal Coupling Analysis of Dual-Redundancy BLDCM Based on 270 V

Performance Analysis of DC-Biased Modular Linear Variable Flux Reluctance Machines

Comparison of Dual 3-Phase Modular Permanent Magnet Machines with Overlapping/Non-overlapping Windings and Redundancy

A Novel Magnetization Failure Detection Method for 1-Phase BLDC Motor Based on Back-EMF Test

Analysis and Suppression of Cross-Coupling Demagnetization in Dual Permanent Magnet Machine for Direct-Drive Application

Design and Analysis of Dual-Magnet BLDCM for Momentum Wheel

Design and Analysis of a High Efficient Multi-Segment Redundancy Linear Motor

Electromagnetic and Thermal Coupling Analysis of a Water-Cooled Double-Sided Permanent Magnet Linear Synchronous Motor

Analysis and Control of Multiphase Permanent-Magnet Bearingless Motor With a Single Set of Half-Coiled Winding

Thrust Optimization and Thermal Analysis of a Water-Cooled Double-Sided Permanent Magnet Linear Synchronous Motor

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

Enhanced Fault Tolerance of Dual Three-Phase Permanent Magnet Motor With Three-Redundancy Control

Multi-field Coupled Analysis of a Permanent Magnet Synchronous Motor: Application to High Speed Rail Traction

Design and analysis on switched reluctance motor system using field-circuit coupled method

The Redundant Design and Reliability Analysis of Magnetic Bearings Used for Aeroengine

Bi-directional Electromagnetic-Thermal Coupling Analysis For Permanent Magnet Traction Motor Under Complex Operating Conditions

Analysis and Calculation of Radial Electromagnetic Force of Circular Winding Brushless DC Motor

Analysis and Simulation on Commutation Torque Ripples of Six-Phase Brushless DC Motor

Study on Process Derivation and Characteristic Analysis for BLDC Motor Design Using Dual Rotor Structure with High Torque Density

Design of Double Redundancy Controller for Electric Actuator Based on Dual three-phase PMSM

Fault Tolerant Control for Open Winding Brushless DC Motor with Power Device Failure