Abstract:When transporting nanoparticles with diameters ranging from 8 to 550nm through pipe bends, the penetration efficiency is related to the flow property, bend curvature and particle property. In the present study, the moment equations for nanoparticles are derived and solved with the Taylor-series expansion moment method by considering the combined effect of particle diffusion, coagulation and breakage. The results show that the particle number concentration increases linearly with time at the initial stage, then grows slowly, and finally attains a stable state after dimensionless time t is larger than 10. The increase of Dean number leads to an increase of averaged particle number concentration from 0 to 0.135–1.372 depending on the values of Dean number and Schmidt number. The average particle diameter increases with time, and decreases with increasing Dean and Schmidt numbers. The average particle polydispersity increases slowly at the initial stage, and then grows fastly. As the decreases of Schmidt and Dean numbers, the average particle polydispersity increases. More particles, especially large particles, gather near the outer bend wall. Then the penetration efficiencies are calculated and the corresponding experiments are carried out. The results show that the penetration efficiencies increase with increasing Dean number under laminar flow condition. The effect of Dean number on the penetration efficiency is dependent on Schmidt number. There exists a critical value of Dean number beyond which the penetration efficiency turns from increment to decrement, and this critical value is dependent on Schmidt number. The penetration efficiencies increase with increasing Schmidt number. The penetration efficiencies are higher in the case of higher Dean number than that of lower one, and the difference in the higher and lower Dean number becomes small when Schmidt number is larger than 20,000. Finally, the expressions of penetration efficiency as a function of related parameters for the particles with diameters ranging from 8 to 550nm are derived based on the numerical and experimental data. The expressions not only cover the present and previous experimental data, but can also be used to the case with wider range of Dean and Schmidt numbers.

Prediction of Nanoparticle Transport and Deposition in Bends

Transport and deposition of nanoparticles in square bend tubes

Transport and Deposition of Nanoparticles in Bend Tube with Circular Cross-Section

Research on the transport and deposition of nanoparticles in a rotating curved pipe

Distribution and penetration efficiency of nanoparticles between 8–550nm in pipe bends under laminar and turbulent flow conditions

Nanoparticle Transport and Coagulation in Bends of Circular Cross Section Via a New Moment Method

Nanoparticle Distribution in A Rotating Curved Pipe Considering Coagulation and Dispersion

Penetration Efficiency of Nanoparticles in a Bend of Circular Cross-Section

Distribution and Penetration Efficiency of Cylindrical Nanoparticles in Turbulent Flows Through a Curved Tube

Comparison of Micro- and Nano-Size Particle Transport and Depositions in 90 Degree Bend Microchannel

Distribution and Deposition of Cylindrical Nanoparticles in a Turbulent Pipe Flow

Nanoparticle Migration in a Fully Developed Turbulent Pipe Flow Considering the Particle Coagulation

Effect of Coagulation and Diffusion on Nanoparticle Distribution in a Fully Developed Turbulent Boundary Layer

Research on Deposition and Orientation Characteristics of Cylindrical Particles in Gas-Solid 2-Phase Turbulent Flow in Curved Tubes

Friction Factor and Heat Transfer of Nanofluid in the Turbulent Flow Through a 90° Bend

Aerosol deposition in 90-degree bends: An enhanced empirical equation and a design concept of reducing losses

Solution of General Dynamic Equation for Nanoparticles in Turbulent Flow Considering Fluctuating Coagulation

Nanoparticle coagulation in a planar jet via moment method

Distribution of non-spherical nanoparticles in turbulent flow of ventilation chamber considering fluctuating particle number density

Numerical Simulation on the Deposition of Nanoparticles under Laminar Conditions

Sedimentation effects on particle position and inertial deposition in 90° circular bends