Abstract:Due to its ease of implementation without an additional transmitter, radar communication integrated systems using conventional communication signals have become an effective means for monitoring unmanned aerial vehicles and other aircraft. However, their non-ideal radar signal form causes strong signals to mask weak signals, and clutter suppression is required to detect a target. As the energy of a target signal is extremely low and conventional clutter suppression methods have limited performance, the residual clutter persists after the time-varying clutter is suppressed, resulting in many false alarm points on the processed range–Doppler (RD) map. The two-dimensional distribution of these false alarms on the range–Doppler is very similar to that of the target and difficult to discriminate, which seriously affects target detection and tracking. To reduce false alarm points and improve the performance of target detection, the difference in the spatial–temporal stationarity between a target signal and clutter in a short time is discussed in this paper; a radar false alarm suppression method based on a target’s spatial–temporal stationarity is proposed by using the difference in the stationarity between the target signal and false alarm points in the range, Doppler, energy and azimuth. In this algorithm, to ensure the short-time stationarity of the target, the RD map of the short-time interval sub-frames is obtained by using the sliding matching filtering method and the peak points are extracted. Then, the Mahalanobis distance between the peak points of each sub-frame is used to eliminate the false alarm points. Finally, the false alarm points are further eliminated by target tracking and the real target information to improve the radar target detection performance. The simulation experiments show that this method can eliminate more than 90% of the false alarms points while maintaining the target detection performance. The analysis of actual data obtained from the field experiment indicate that the implementation of this algorithm, which effectively suppresses false alarms, leads to improved target detection outcomes. These enhancements can facilitate the tracking of UAVs and other aircraft.

Study on False Target in Ionospheric Phase Perturbation Correction using PGA

Evaluation of the Method Based on Psr Techniques for Target Detection in Reverberation

Evaluation of Infrared Deception Jamming Effectiveness of False Targets Based on GBVS

Doppler bias analysis and compensation for ISAR targets

Study on the Correction Algorithm of Ionospheric Phase Perturbation with Large Amplitude in OTHR

Parallel array signal processing technology for spatial phase distortion correction in heterodyne detection

A Method To Correct The Frequency Shift Of Broadening Bragg Peaks Contaminated By Ionosphere

An Effective Target Tracking Algorithm with Anti-Rgpo Ability

Time-reversal Target Detection with Interactive Transmission and Reception

A Novel Approach to Moving Target Screening for UHF-Band SAR GMTI.

False Target Detection in OFDM-based Joint RADAR-Communication Systems

A Novel Phase Distortion Correction Method Based on Temporal Correlation Matrix

False target suppression method based on stepped frequency and Doppler filtering

A Linearly Continous False Alarm Removing Method in a Multichannel SAR-GMTI System

Moving Target Detection for Spaceborne MIMO-SAR Based on Interferogram

A cascaded approach for correcting ionospheric contamination with large amplitude in HF skywave radars.

A SAR-GMTI Approach Based on Moving Target Focusing

An Extended Target Autofocus Algorithm for High Resolution SAR Imaging

An Adaptive False Target Suppression and Radial Velocity Estimation Method of Moving Targets Based on Image-Domain for High-Resolution and Wide-Swath SAR

High-vivid Uniformly-moving Target Deception Jamming Method Against SAR-GMTI Based on Inverse Omega-K Algorithm

Radar False Alarm Suppression Based on Target Spatial-Temporal Stationarity for UAV Detecting