Abstract:By using a specially contrived experimental technique, the partition equilibrium of 4-carboxybenzaldehyde (4-CBA) between crude terephthalic acid crystals and the corresponding aqueous acetic acid solution was achieved. The equilibrium mole fractions of 4-CBA in both the liquid and solid phases were measured over a temperature range from (423.2 to 453.0) K, and the mass fractions of acetic acid in the solvent mixtures ranged from 0.800 to 0.995. The partition coefficients, defined as the ratio of the equilibrium mole fraction of 4-CBA in the solid phase to the equilibrium mole fraction of 4-CBA in the liquid phase, were experimentally determined. The experimental results show that: (1) within the temperature range of the measurements, the partition coefficient shows a decreasing trend as the temperature increases at a constant solvent composition, and (2) within the solvent composition range of the measurements, the partition coefficient increases with increasing water content in the solvents at a constant temperature. The experimental data are correlated by the nonrandom two liquids (NRTL) activity coefficient model, and the model parameters are determined in a nonlinear optimization. The fit of the correlated results is fairly good. The comparison of the predicted and experimental partition coefficients at temperatures of (423.2 to 453.0) K and the mass fraction of acetic acid in the solvent mixture at 0.950 shows that the NRTL activity coefficient model could be used as a suitable toot in predicting the partition coefficient of 4-CBA between crude terephthalic acid crystals and the corresponding aqueous acetic acid solution.

Distribution Coefficient of Caprolactam and Methyl Caprolactam Using Benzene or Toluene As Extractants: Experiments and Prediction

Liquid-liquid equilibria of the quaternary system water + caprolactam + 1-octanol + ammonium sulfate

Phase Equilibrium Calculations in Mixtures Containing Caprolactam with a UNIFAC Model

Liquid liquid equilibria of the quaternary system water plus caprolactam plus 1 octanol plus ammonium sulfate

Selection and Evaluation of a New Extractant for Caprolactam Extraction

Calculations of Physical Properties and Phase Equilibrium in Polyethylene Glycol Terephthalate Esterification System

Modeling of Molecular Weight and Copolymer Composition Distributions for Ethylene‐propylene Solution Copolymerization

Solubility behavior and thermodynamic properties of caprolactam in four pure solvents and two cosolvent mixtures

Measurement and Correlation for Solubility of (S)-(+)-2,2-dimethyl-cyclopropane Carbox Amide in Different Solvents

Modelling and Prediction of Toluene Adsorption Saturation Basing on Characteristic Values of Activated Carbons

Partition Coefficient of 4-Carboxybenzaldehyde Between Crude Terephthalic Acid Crystals and the Corresponding Aqueous Acetic Acid Solution at (423.2 to 453.0) K

Caprolactam Recovery by A Column Packed with Polysulfone Microcapsules Containing 1-Octanol

Solution Thermodynamics of Caprolactam in Different Monosolvents

Preparation of Uniform Microcapsules Containing 1-Octanol for Caprolactam Extraction

Recovery of Caprolactam from Waste Water in Caprolactam Production Using Pulsed-sieve-plate Extraction Column

Characterization on the Chain Heterogeneity of L-Lactide and Epsilon-Caprolactone Copolymers

The predictive capability of the UNIFAC equation for the calculation of liquid-liquid equilibria with chemical reactions in Tributyl Phosphate Extraction Systems for Nitric Acid and Uranyl Nitrate

Extraction of caprolactam from aqueous ammonium sulfate solution in pulsed packed column using 250 Y mellapak packings

Prediction of Solubility for Solvent/Polymer Mixture with UNIFAC-FV and GCLF-EOS Model

Determination of impurities in industrial caprolactam produced from toluene by SPME and GC–MS

Absorption and desorption of gaseous toluene by an absorbent microcapsules column.