Analysis of Chemical Components in Tobacco Flavors Using Stir Bar Sorptive Extraction and Thermal Desorption Coupled with Gas Chromatography-Mass Spectrometry

Hou Ying,Yang Lei,Wang Baoxing,Xu Jicang,Yang Yong,Yang Yan,Cao Qiue,Xie Xiaoguang

DOI: https://doi.org/10.1016/s1872-2059(06)60026-6

2006-01-01

Abstract:A novel method for the analysis of chemical components in tobacco flavors was established using stir bar sorptive extraction SBSE and thermal desorption coupled with gas chromatography-mass spectrometry GC-MS. The different parameters affecting the extraction of the analytes from the samples to the poly dimethylsiloxane PDMS coated stir bars and the conditions affected thermal desorption were investigated. The optimized extraction conditions were that the sample was extracted with a stir bar 10 mm length and 0. 5 mm thickness at 1 100 r/min for 1 h at ambient temperature. Desorption was carried out from 20 degrees C ramped to 250 degrees C at 60 degrees C/min and hold for 2 min under a helium flow of 50 mL/min in the splitless mode while maintained the cryofocusing temperature of - 100 degrees C in a CIS-4 injector of the GC-MS system. Finally the CIS-4 injector was raised to a temperature of 280 degrees C and the analytes were separated by GC and detected by MS using full scan mode m/z 35 - 400. Under the described conditions about 30 components were identified from the tobacco flavors and the major components included esters ketones aldehydes etc. The average relative standard deviation RSD of peak areas of 30 components for 6 determinations was less than 10%. The good repeatability made SBSE a powerful tool for the routine quality control analysis of chemical components in tobacco flavors.