Abstract:Wire-, ribbon-, and sphere-like nanostructures of polypyrrole have been synthesized by solution chemistry methods in the presence of various surfactants (anionic, cationic, or nonionic surfactant) with various oxidizing agents [ammonium persulfate (APS) or ferric chloride (FeCl3), respectively]. The surfactants and oxidizing agents used in this study have played a key role in tailoring the nanostructures of polypyrrole during the polymerization. It is inferred that the lamellar structures of a mesophase are formed by self-assembly between the cations of a long chain cationic surfactant [cetyltrimethylammonium bromide (CTAB) or dodeyltrimethylammonium bromide (DTAB)] and anions of oxidizing agent APS. These layered mesostructures are presumed to act as templates for the formation of wire- and ribbon-like polypyrrole nanostructures. In contrast, if a short chain cationic surfactant octyltrimethylammonium bromide (OTAB) or nonionic surfactant poly(ethylene glycol) mono-p-nonylphenyl ether (O pi-10) is used, sphere-like polypyrrole nanostructures are obtained, whichever of the oxidizing agents mentioned above is used. In this case, micelles resulting, from self-assembly among surfactant molecules are envisaged to serve as the templates while the polymerization happens. It is also noted that, if anionic surfactant sodium dodeyl surfate (SDS) is used, no characteristic nanostructures of polypyrrole were observed. This may be attributed to the doping effect of anionic surfactants into the resulting polypyrrole chains, and as a result, micelles self-assembled among surfactant molecules are broken down during the polymerization. The effects of monomer concentration, surfactant concentration, and surfactant chain length on the morphologies of the resulting polypyrrole have been investigated in detail. The molecular structures, composition, and electrical properties of the nanostructured polypyrrole have also been investigated in this study.

Synthesis of polyaniline nanostructures with controlled morphology by a two-phase strategy

A novel strategy for the synthesis of polyaniline nanostructures with controlled morphology

Fabrication of one dimensional polyaniline nanofibers by UV-assisted polymerization in the aqueous phase.

Synthesis of Polyaniline Nanostructure with Controlled Morphology in Mixed Solvent

Structural-Controlled Synthesis of Polyaniline Nanoarchitectures Using Hydrothermal Method

Synthesis and Properties of Polyaniline With Nanostructure

Development of preparation of polyaniline micro/nano structures through chemical oxidative polymerization

Studies on Multi Morphology of Polyaniline Guided by Alkali

Formation of Nano-/Microstructures of Polyaniline and Its Derivatives

The design, synthesis and characterization of polyaniline nanophase materials

Hydrothermal Synthesis of Polyaniline Mesostructures

Amino-Fe3o4 Microspheres Directed Synthesis Of A Series Of Polyaniline Hierarchical Nanostructures With Different Wettability

Controlled Synthesis of Polyaniline Nanostructures with Junctions Using in Situ Self-Assembly of Magnetic Nanoparticles

Polyaniline Micro-/Nanostructures: Morphology Control and Formation Mechanism Exploration

Preparation of High-Yield Polyaniline Nanofibers Via an Unstirred Polymerization

Effective synthesis to control the growth of polyaniline nanofibers by interfacial polymerization

Controllable synthesis of conducting polypyrrole nanostructures.

Cyclic Polyaniline Nanostructures from Aqueous/organic Interfacial Polymerization Induced by Polyacrylic Acid

A Novel Strategy for the Synthesis of Sheet-Like Polyaniline.

Synthesis and Mechanism of Polyaniline Nanotubes with Rectangular Cross Section Via in Situ Polymerization

Controlled Synthesis of Polyaniline-Based Nanomaterials with Self-Assembly and Interface Manipulation