Abstract:The aim of this research work is to optimize the synthesis of Li4SiO4 by a solid state method to maximize CO2 capture. This includes evaluating the main characteristics of the synthesised material which enhance the CO2 uptake performance. Starting from Li2CO3 and SiO2 pure reagents, the effect of the sintering process conditions (heating rate, synthesis temperature and holding time) of the previously mixed powders has been studied. The samples were characterized by N2 physisorption, particle size distribution and X-ray diffraction. The evaluation of the CO2 uptake performance of the samples has been carried out at 600 °C using a thermobalance under a flow of almost pure CO2. Unreacted Li2CO3 is present at low synthesis temperatures, and its content in the synthesised material decreases when higher temperatures are used, so complete conversion to Li4SiO4 is reached at 900 °C. At this temperature, the maximum CO2 uptake was found to be 20%, although it was yet far from the stoichiometric CO2 uptake value of 36.7%. The holding time at a synthesis temperature of 900 °C was then varied and a maximum CO2 uptake of 30.5% was obtained for a holding time of 2 h. Finally, under the optimised synthesis temperature and holding time conditions, the heating rate was varied. A value of 5 °C min−1 was found as the optimum one as the use of either lower or higher heating rates has a negative effect on the CO2 uptake performance. As crystalline phases, the particle size and BET surface area were very similar among all the prepared samples at 900 °C; the crystal size was identified as the main physical property that could explain the CO2 uptake performance of the samples, i.e., the lower the crystal size, the higher the CO2 uptake.

CO_2 Absorption of Li_4SiO_4 at High Temperature

Co2 Absorption Of Li4sio4 At High Temperature

Performance of Nano-Caco3 Coated with SiO2 on CO2 Adsorption at High Temperature

Ca based high temperature CO2 absorbents for sorption enhanced reforming process

Calcination–carbonation Durability of Nano CaCO3 Doped with Li2SO4

Optimization of Li4SiO4 synthesis conditions by a solid state method for maximum CO2 capture at high temperature

Enhanced high temperature cyclic CO2 capture on Li4SiO4 sorbent from two-dimensional SiO2 nanomeshes

Preparation and Co2 Sorption/Desorption of N-(3-Aminopropyl) Aminoethyl Tributylphosphonium Amino Acid Salt Ionic Liquids Supported into Porous Silica Particles

Synthesis and Adsorption Process of Lithium Taking Used as High-Temperature CO2 Sorbents

Molten shell-activated, high-performance, un-doped Li4SiO4 for high-temperature CO2 capture at low CO2 concentrations

Carbon dioxide absorption in packed bed of lithium orthosilicate pebbles

CO2 high-temperature sorbent (Al, Fe, Ti) CO-doped Li4SiO4 from fly ash-derived SiO2 aerogel: In-situ synthesis, enhanced capture ability and long cycle stability

High-temperature CO2 sorption over Li4SiO4 synthesized from diatomite: study of sorption heat and isotherm modeling

The Study Of Li2zro3 Used For Absorption Of Co2 At High Temperature

Novel synthesis of tailored Li4SiO4-based microspheres for ultrafast CO2 adsorption

A new method for the preparation of high-purity CO2-absorbing Li3NaSiO4 powder using lithium silicate and sodium carbonate

Evaluation of the formation and carbon dioxide capture by Li4SiO4 using in situ synchrotron powder X-ray diffraction studies

Adsorption of high-temperature CO2 by Ca2+/Na+-doped lithium orthosilicate: characterization, kinetics, and recycle

The Influencing Factor for CO2 Absorption of Li2ZrO3 at High Temperature

Synthesis and CO2-absorption properties of lithium zirconate

Influence of the concentration of CO2 and SO2 on the absorption of CO2 by a lithium orthosilicate-based absorbent