Abstract:1,8-diazabicyclo [5.4.0] undec-7-ene (DBU)-glycerol system is a potential chemical absorbent of CO2. The surface tension of DBU-glycerol and CO2-DBU-glycerol systems at temperatures from 288.1 K to 323.1 K were studied using the Wilhelmy-plate method. In both systems, the surface tension decreases with increasing temperature, and the surface tensions of the DBU-glycerol and CO2-DBU-glycerol systems decrease by approximately 13-19% and 17-35%, respectively, over the measured temperature range. In the DBU-glycerol binary system, the surface tension decreases gradually with increasing DBU mole fraction. The excess surface tension was calculated and the concentration of DBU at the surface was found to be higher than that of the bulk. Four models (Redlich-Kister, FLW, WCH, and Jouyban-Acree method) were compared to model the surface tension of the DBU-glycerol system. The Kalies and proportionality methods were compared for modeling the surface tension of the CO2-DBU-glycerol solution. It was found that when the mass content of CO2 (omega(CO2)) based on the total mass of DBU and glycerol is less than 8%, the surface tension of CO2-DBU-glycerol is higher (maximum 31.3%) than that of DBU-glycerol. The Jouyban-Acree method and proportionality method are the best for calculating the surface tension of DBU-glycerol and DBU-glycerol-CO2 mixtures, respectively. The average relative deviations in the Jouyban-Acree and the proposed proportionality methods are 0.98% and 2.06%, respectively. Surface tension data can provide basic and useful information in the design of absorption equipment and subsequent operation for CO2 capture with DBU-glycerol solvent. (C) 2018 Elsevier Ltd.

Surface tension of diethyl carbonate, 1,2-dimethoxyethane and diethyl adipate

Surface Tension of Diethyl Ether, Diisopropyl Ether, and Dibutyl Ether

Surface Tension of Dimethoxymethane and Methyl Tert-Butyl Ether

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Surface Tension of Dimethyl Ether from (213 to 368) K

Measurements of viscosity and density of diethyl carbonate

Surface Tension of Four Oxygenated Fuels: Experiment and Correlation

Densities and Surface Tensions of Trimethylbenzene + Dimethyl Carbonate or + Diethyl Carbonate at 298.15 K and 313.15 K

Mutual Diffusion Coefficients of Diethyl Carbonate and Diethyl Adipate in Heptane at T = (278.15 to 338.15) K under Atmospheric Pressure

Density, Viscosity, and Surface Tension at 293.15 K and Liquid−Liquid Equilibria from 301.15 K to 363.15 K under Atmospheric Pressure for the Binary Mixture of Diethylene Glycol Diethyl Ether + Water

Densities And Surface Tensions Of Propyl Acetate Plus Xylenes Or Plus Ethylbenzene From (298.15 To 308.15) K

Surface Tension of 2,2-Dimethylbutane from (233 to 378) K

Surface tension of dimethyl ether+propane from 243 to 333K

Density and Viscosity Measurements of Diethyl Adipate from (303 to 373) K and up to 20 MPa

Estimation of the Surface Tension of Liquid Carbon Dioxide

Studies on Surface Tension of 1,8-Diazabicyclo [5.4.0] Undec-7-ene (Dbu)-Glycerol and CO2-DBU-glycerol Solutions at Temperatures from 288.1 K to 323.1 K

Surface Tension for the 1,1,1-Trifluoroethane (R-143A)+1,1,1,2-tetrafluoroethane (R-134A) System

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Surface Tension Measurements of Propane (R-290) and Isobutane (R-600A) from (253 to 333) K

Surface Tension Measurements of Difluoromethane (R-32) and the Binary Mixture Difluoromethane (R-32) + 1,1,1,2-Tetrafluoroethane (R-134a) from (253 to 333) K

Surface Tensions of Mixtures of Diesel Oil or Gasoline and Dimethoxymethane, Dimethyl Carbonate, or Ethanol