Abstract:Constructing composite electrodes is considered to be a feasible way to realize high-specific-capacity Li-ion batteries. The core–double-shell-structured @TiO2 would be an ideal design for such batteries, considering that carbon (C) can buffer the volume change and TiO2 can constrain the structural deformation of Si. Although the electrochemical performance of the shells themselves is relatively clear, the complexity of the multishell heterointerface always results in an ambiguous understanding about the influence of the heterointerface on the electrochemical properties of the core material. In this work, a multilayer film model that can simplify and simultaneously expand the area of the heterointerface is used to study the heterointerfacial behavior. First, a multilayer film TiO2/C with different numbers of TiO2/C heterointerfaces is studied. It shows that the electrochemical performance is enhanced apparently by increasing the number of TiO2/C heterointerfaces. On the one hand, the TiO2/C heterointerface exhibits a strong lithium-ion storage capacity. On the other hand, the TiO2/C heterointerface appears to effectively promote the local Li-ion concentration gradient and thus boost the Li-ion transport kinetics. Then, TiO2/C is combined with Si to construct a composite anode Si/C/TiO2. An obvious advantage of TiO2/C over single TiO2 and C is observed. The utilization rate of Si is greatly improved in the first cycle and reaches up to 98% in Si/C/TiO2. The results suggest that the electrochemical performance of Si can be greatly manipulated by the heterointerface between the multishells.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c01589?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c01589</a>.Cross-sectional SEM morphologies; XRD patterns and Raman spectra of Group A and Group B samples; cycling performance of pure amorphous TiO2 and C films at a current density of 0.2 A g–1; CV curves obtained at a scanning rate of 0.1 mV s–1 and the 1st, 2nd, 10th, 100th, and 200th cycle charge–discharge platform curves derived at a current density of 0.2 A g–1 for TC2, TC3, TC4, and TC5; CV curves at different scanning rates after five cycles and the fitting apparent diffusion coefficients of all the samples; CV curves at different scanning rates after five cycles and the fitting apparent diffusion coefficients of the TiO2/Ge and TiO2/Si electrodes; CV curves at a scanning rate of 0.1 mV s–1 and the galvanostatic charge/discharge curves at a current density of 230 mA g–1 after different cycles for the Si/C, Si/TiO2 and Si/C/TiO2 electrodes; EIS spectra before and after 200 cycles for the Si/C, Si/TiO2, and Si/C/TiO2 electrodes; and the corresponding fitting results (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c01589/suppl_file/am1c01589_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Electrochemical Investigation on Silicon/titanium Carbide Nanocomposite Film Anode for Li-ion Batteries

Investigation of crack patterns and cyclic performance of Ti-Si nanocomposite thin film anodes for lithium ion batteries

Electrochemical Properties of a Mesoporous Si∕TiO[sub 2] Nanocomposite Film Anode for Lithium-Ion Batteries

Nanostructured Si/TiC Composite Anode for Li-ion Batteries

Electrochemical Properties of Si/LiTi2O4 Nanocomposite As Anode Materials for Li-ion Secondary Batteries

Electrolytic preparation of porous TiSi2/Si nanocomposites and the electrochemical performances as lithium-ion battery anode

Nanocomposites As Anode for Lithium-Ion Battery

Si/Ti3SiC2 Composite Anode with Enhanced Elastic Modulus and High Electronic Conductivity for Lithium-Ion Batteries

Study on lithiation/delithiation properties of Si-TiN composited nanoparticles as anode materials for lithium-ion batteries

Assessment of the Electrochemical Behaviour of Silicon@carbon Nanocomposite Anode for Lithium-Ion Batteries

Boosting Lithium-Ion Transport Kinetics by Increasing the Local Lithium-Ion Concentration Gradient in Composite Anodes of Lithium-Ion Batteries

In Situ Synthesis of a Si/CNTs/C Composite by Directly Reacting Magnesium Silicide with Lithium Carbonate for Enhanced Lithium Storage Capability

In Situ TEM Investigation of Congruent Phase Transition and Structural Evolution of Nanostructured Silicon/Carbon Anode for Lithium Ion Batteries

Si/C Composites for High Capacity Lithium Storage Materials

Microstructure and Li alloy formation of nano-structured amorphous Si and Si/TiN composite thin film electrodes

Si@C/TiO 2 @C/Hollow-C Nanocomposite as a Lithium-Ion Battery Anode Produced by Refining Silicon and Ti–6Al–4V Residuals

Preparation and Study on Si/Ag/C Composite As Anode Material for Lithium Ion Batteries

Nano/micro-structured Si/CNT/C composite from nano-SiO2 for high power lithium ion batteries

Silicon/Carbon Nanoparticles Assembled with Multifunction Carbon Nanotubes/Sheets as High-Performance Anode of Lithium-Ion Batteries

Binary Carbon Modification Promoting the Electrochemical Performance of Silicon Anode for Lithium‐Ion Batteries

Si/C Composite Embedded Nano-Si in 3D Porous Carbon Matrix and Enwound by Conductive CNTs As Anode of Lithium-Ion Batteries