Abstract:Titanium oxide nanotube arrays (TiO2-NTAs) with different diameters and lengths are prepared by anodization of titanium foils in a water/ethylene glycol solution (5:95 V/V) containing 0.3 wt% NH4F. The effects of the diameters, lengths and crystalline phases of the NTAs on the photocatalytic (PC) activity are systematically evaluated. Larger pore diameter results in higher PC activity. The PC activity increases initially and then decreases with lengths for TiO2-NTAs and the optimal length that yields the highest PC activity is observed to be 6.2 microm. The crystalline phase and corresponding PC activity depend on the calcination temperature and their relationship is also investigated. The amorphous-to-anatase and anatase-to-rutile phase transitions initially occur at 300 and 500 degrees C, respectively. The PC activity of TiO2-NTAs initially increases with calcination temperature from 250 to 500 degrees C and then decreases at higher calcination temperature. The enhanced PC activity observed from the samples annealed at 250-450 degrees C is attributed to the better anatase crystalline structure at higher calcination temperature. The highest PC activity with regard to photodecomposition of methyl orange is observed from TiO2-NTAs calcined at 500 degrees C, which coincides with the anatse-to-rutile phase transformation. The synergistic effect of the anatase TiO2-NTAs and rutile barrier layers facilitate interfacial electron transfer consequently enhancing the PC activity. Further elevation of the calcination temperatures to 550 and 600 degrees C exhibits diminished PC activity because the NTs become shorter due to conversion of the bottom of anatase NTs into rutile film.

Crystal phase transition and properties of titanium oxide nanotube arrays prepared by anodization

Temperature-dependent differences in wettability and photocatalysis of TiO 2 nanotube arrays thin films

Crystallization and Phase Transition of Titanium Oxide Nanotube Arrays

Fabrication and Properties of Tio2 Nanotube Arrays Using Glycerol-Dmso-H2o Electrolyte

Influence of Synthesis Parameters on Photocatalytic Properties of Titanium Dioxide Nanotube Arrays

Preparation and Characterization of TiO2 Nanotube Arrays on Porous Titanium

The Formation of Micrometer-Long TiO2nanotube Arrays by Anodization of Titanium Film on Conducting Glass Substrate

Phase transformation and thermal structure stability of titania nanotube films with different morphologies

Synthesis and investigation of TiO2 nanotube arrays prepared by anodization and their photocatalytic activity

Hydrothermal crystallization and electrochemical properties of one-dimensional TiO2 nanotube arrays

Fabrication And Fluorescence Property Of Titanium Dioxide Nanotube Arrays By Anodizing Processes

Preparation and Characterization of TiO2 Nanotube Arrays Via Anodization of Titanium Films Deposited on FTO Conducting Glass at Room Temperature

Fabrication and Photoelectric Properties Research of TiO2 Nanotube Arrays

Electrochemical Fabrication and Formation Mechanism of Tio2 Nanotube Arrays on Metallic Titanium Surface

Crystallization and high-temperature structural stability of titanium oxide nanotube arrays

Influence of Structure Parameters and Crystalline Phase on the Photocatalytic Activity of TiO2 Nanotube Arrays.

Fabrication of highly ordered titanium dioxide nanotube array and investigation of its photocatalytic activity

Fabrication of TiO2 Nanotube Arrays by a Two-Step Anodic Oxidation

Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method: Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method

Fabrication and photoluminiscent properties of titanium oxide nanotube arrays

Preparation Of Tio2 Nanotube Arrays And Their Photoeleetrochemical Properties