Abstract:The self-sustained flapping of a three-dimensional flexible plate in a uniform viscous flow is numerically simulated with a fictitious domain method. The effects of the various non-dimensional control parameters including the Reynolds number, the density ratio, the dimensionless shear modulus, the length–thickness ratio, and the width–length ratio on the flapping of the plate are investigated. The results show that there exist two flapping modes: symmetrical and asymmetrical flapping about the centerline in the spanwise direction. Near the critical point a decrease in the plate width–length ratio, or the increase in the Reynolds number or the reduced velocity (a combination of the density ratio, the dimensionless shear modulus, and the length–thickness ratio) can make symmetric (or nearly symmetric) flapping become asymmetric. It is found that the flapping amplitude is mainly controlled by the density ratio and the dimensionless elastic modulus, while the frequency by the density ratio and the length–thickness ratio. In addition, the flapping amplitude and frequency are affected significantly by the confinement effect of the computational domain, and normally enhanced as the confinement effect becomes stronger. The effects of the plate width and the mass ratio (i.e., the ratio of the length–thickness and density ratios) on the critical reduced velocities are examined. The results indicate that when the fluid–plate mass ratio (or the plate length–thickness ratio) is relatively small there exist two significantly different critical velocities for the flapping instability, depending on the strength of initial plate deformation, a hysteresis phenomenon. No obvious hysteresis can be observed when the fluid–plate mass ratio (or the plate length–thickness ratio) is large.

COMPARE OF TIME DOMAIN METHOD WITH FREQUENCY DOMAIN METHOD IN NONLINEAR FLUTTER ANALYSIS FOR PANELS OF SUPERSONIC AIRPLANE

Investigation of the Flutter Stability of a Transonic Fan with Inlet Distortion

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

Aerothermoelastic analysis of curvilinear fiber variable stiffness laminated panels in supersonic flow

Nonlinear flutter of composite laminated panels with local non-smooth friction boundaries

Nonlinear supersonic flutter of a composite panel backed by an acoustic cavity with finite-amplitude sound waves

Numerical study on the nonlinear characteristics of shock induced two-dimensional panel flutter in inviscid flow

Mechanism of Single-mode Panel Flutter in Low Supersonic Flow

High-frequency vibration analysis of panels under aerothermoelastic effects in supersonic airflow by an energy finite element method

Supersonic flutter analysis of flat composite panels by unified formulation

Suppression of panel flutter response in supersonic airflow using a nonlinear vibration absorber

Time-Delayed Feedback Control for Flutter of Supersonic Aircraft Wing

Investigations On Nonlinear Aerothermoelastic Behaviors Of Multilayered Composite Panels Subject To Frictional Boundaries And Random Acoustic Loads In Supersonic Flow

Nonlinear panel flutter analysis using a gen- eral higher-order shear deformation plate theory

Nonlinear Aero-Thermo-Elastic Stability Analysis of a Curve Panel in Supersonic Flow Based on Approximate Inertial Manifolds

Panel flutter analysis of plate element based on the absolute nodal coordinate formulation

Experimental and Numerical Flutter Analysis Using Local Piston Theory with Viscous Correction

Numerical simulations of the flapping of a three-dimensional flexible plate in uniform flow

Supersonic Flutter Analysis for Aeroelastic Multibody Systems

Test simulation study on flutter characteristics of airfoil

A NUFFT Technique for Flow Fluctuation Analysis Based on the Unsteady Flow Simulation with Variable Physical Time Stepping Scheme