Abstract:With the development of intelligent and electric vehicles, higher requirements are put forward for the active braking and regenerative braking ability of the braking system. The traditional braking system equipped with vacuum booster has difficulty meeting the demand, therefore it has gradually been replaced by the integrated braking system. In this paper, a novel Integrated Braking System (IBS) is presented, which mainly contains a pedal feel simulator, a permanent magnet synchronous motor (PMSM), a series of transmission mechanisms, and the hydraulic control unit. As an integrative system of mechanics-electronics-hydraulics, the IBS has complex nonlinear characteristics, which challenge the accurate pressure control. Furthermore, it is a completely decoupled braking system, the pedal force doesn’t participate in pressure-building, so it is necessary to precisely identify driver’s braking intention. To improve the control accuracy of the system, this paper proposed a novel pressure control strategy based on driver braking intention identification. Firstly, the structure and working principle of the novel integrated braking system was introduced. Secondly, the driver's braking intention identification strategy was designed. Thirdly, Considering the nonlinear and dynamic characteristics of the system, a cascade closed-loop control strategy including a pressure loop by the feedforward-feedback method, a position loop by the sliding-mode control method, and current loop with friction compensation was proposed. Finally, based on dSPACE products, a hardware-in-the-loop (HiL) experimental bench was built for algorithm verification. The HiL experiment results show that the pressure control strategy has the advantages of accurate response, the braking system pressure follows the driver's expected pressure well.

Design and Analysis of Measurement Precision of Intelligent Pressure Detection System

Design of the Structure of the Sensor in the Brake Monitoring System for Locomotive

Research and Design of the Pressure Simulator System

Study on Monitoring System of Braking State of Locomotive Unit Brake

Research on Measurement Principle and Key Measuring Devices of Pressure Change Rate for Electronically Controlled Pneumatic Brake of Commercial Vehicle Based on Poiseuille’s Law

Design of Train Integrity Monitoring System

Design Of Braking Capability Testing System For Daqin Heavy Haul Freight Train

Real-time Monitoring and Fault Diagnosis Expert System for Locomotive Braking System

Design of test system for pressure damage of automobile braking parts

Design and Error Analysis on Pressure Measurement System of Low Speed Pressurized Wind Tunnel

Design and Implementation of Communication System for Air Brake System of Electric Locomotive

The design of a kind of tire pressure online monitoring instrument

System modeling, experimental validation and pressure estimation of the pneumatic braking system

Study of New Type Locomotive Brake Control Method

Design of Locomotive's Accurate Brake Control Unit Based on Intelligent PWM Control

A Novel Design of Train Air Brake Test Instrument

Design of Online Detection System for Natural Frequency of Brake Discs

Design of an Integrated Pressure Test System

Research on a Tyre Pressure On-Line Monitoring and Automatic Warning Instrument

Accurate Pressure Control Based on Driver Braking Intention Identification for a Novel Integrated Braking System

Simulation Modeling and Interface Parameter Design of the Semi‐physical Braking Intelligent Test System