Research on Forming Three Cylinder Crankshaft with Curvilinear Die Parting Surface

YANG Hai,ZHOU Jie,JI Jinjin,LIN Lei,ZHANG Yueting

DOI: https://doi.org/10.14158/j.cnki.1001-3814.2013.03.039

2013-01-01

Abstract:According to the shape character of three cylinder crankshafts,a new forming process was introduced,i.e.baiting-heating-preforming-preforging-finish-forging.The three-dimensional models of crankshaft and die were designed by UG software.In order to improve the filling performance of balance plate,the slope surface and resistance wall were designed in the corresponding part of die.Aiming at the position of high and thin balance plates,the curvilinear die parting surface was taken.So the deformation quantity was reasonably distributed.The forging of numerical simulation has better filling die,the distributing of flash is even and the forging has not lap defect.