Types and origin of Cambrian-Ordovician dolomites in Tarim basin
Shiqiang Wu,Jingquan Zhu,Guoxue Wang,Wenxuan Hu,Juntao Zhang,Xiaolin Wang
IF: 1.468
2008-01-01
Acta Petrologica Sinica
Abstract:Cambrian-Ordovician dolomites in Tarim basin, which are characterized by thickly and extensively distributed horizon, are very important hydrocarbon reservoirs. Detailed petrographic investigations have documented 4 dolomite types and their origins are figured out based on petrographic, chemical, isotopic studies, X-ray diffraction and cathodoluminescence analysis. (1) Mud-silt-sized dolomite consists of anhedral and less ordered micritic crystals and exhibits bright-pink luminescent. It yields the highest Na, K, Sr contents, high δ 13 C, Z values (with the average values of - 0.94‰ and 122.3, respectively) and low Fe Mn contents. It always presents as laminas together with evaporated signatures. These characteristics reveal that this kind of dolomite was formed in hypersaline and oxidizing environment and involved fast dolomitization process. It was dolomitized by evaporated seawater in sabkha environment. (2) Algal laminated dolomite (ALD) is composed of euhedral and finely crystallines (<0.05mm) and its main primary fabric of algal lamination can still be identified. Its δ13C (-0.50‰) and Z (123.2) values are the highest, however, Na, K, Sr contents are the lowest. The appearance of sedimentary pyrite suggests that sulfate reduction was active in these sediments shortly after deposition. These characteristics indicate that ALD was dolomitized during early diagenesis and algae possibly played an important role. The ALD was likely formed under mediation of organic matter and Mg2+ were supplied by magnesium concentrated algal laminites and sea water. The highest δ13 C and Z values don't represent the hypersaline condition but possibly suggest the mediation by organic matter. (3) The dolomite which consists of crystals with cloudy centers and clear rims (CCCR) presents mainly as patchy occurrence, and most of its crystals are euhedral and microsucrosic. Patchy are represented by the distribution of CCCR crystals in the vicinity of or within stylolites. The cores of the dolomites are always rich in inclusions and contain some limestone remnants, but the rims are relatively inclusion-free. The cores exhibit bright-pink luminescent, however, the rims are dull or nonluminescent. The dolomite yields the lowest δ13 C, Z values and the highest Mn content, and its K, Na, Sr, Fe contents are low, and moreover, it is relatively highly ordered. These characteristics reveal that this kind of dolomite was formed under reducing conditions and involved less hypersaline fluids. It can be inferred that the pore fluids which were rich in Mg2+ were responsible for the formation of cloudy cores in shallow early diagenetic environments. Whereas the clear rims were likely formed in subsequent burial into deeper subsurface environments, and the Mg2+ needed for further dolomitization possibly was supplied by the transformations of clay minerals. (4) Neomorphic dolomite consists of coarse, turbid crystals and exhibits sucrosic and mosaic textures. Saddle dolostones are present sometimes indicating it involved a deep burial diagenesis. Zonation and grain-ghost were observed occasionally suggesting strong recrystallization. Dull luminescent together with the highest Fe and high Mn contents, low Na, K, Sr contents point to a reducing and less hypersaline environment. Low δ13 C, the lowest Z value and the highest order degree (average in 0.95) possibly resulted from the recrystallization. The average homogeneous temperature (110.2°C) also indicates deep burial diagenesis. Collectively, these characteristics demonstrate that the neomorphic dolomite was likely formed by recrystallization of pre-existing dolomites during deep burial.