Abstract:The application of magnesium in the automotive industry contributes to reduced fuel consumption and CO2 emissions. Nowadays, most magnesium components in automobiles are manufactured by die casting. In this paper, simulation of the low pressure die casting process of a magnesium wheel that adopts FDM (finite difference method) is presented. Through calculating the temperature and velocity fields during filling and solidification stages, the evolution of temperature and liquid fraction is analyzed. Then, potential defects including gas pores in the middle of the spokes, shrinkage at the top of the rim and the rim/spokes junctions are predicted. The reasons for these defects are also analyzed and the solutions to eliminate them are presented. The air gas pores and shrinkage at the top of the rim are eliminated effectively by reducing the pouring velocity. Furthermore, the cooling capacity at the rim/spokes junctions is also investigated in the paper. Through analysis of the shrinkage defects generated in various cooling modes, it is proven that the cooling pipe system set in the side mould alone is a valid way to enhance the cooling capacity at the rim/spoke junction areas. Finally, the strength analysis is carried out for further verification of the effectiveness of the new cooling method.

Numerical Simulation on Metal Casting Process for Magnesium Alloy Pipe Joints

Numerical Simulation of Filling and Solidification Processes for Magnesium Alloy in Low Pressure Cast Process

Numerical simulation of die casting process of magnesium alloy

Numerical simulation of die casting and vacuum die casting for magnesium alloy AZ91D

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Numerical Simulation of the Pressure Casting Process for Magnesium Alloy Steering Wheel

Numerical Simulation of Filling process of Heat Resistant Mg-RE Alloy Piston in Permanent Mold Casting

Simulation on Die Casting Process for Magnesium Alloy Steering Wheel Frame

Numerical Simulation of Semi-Solid Die-Casting Process of Automobile Aluminum Alloy Part

Numerical simulation on semi-solid die-casting of magnesium matrix composite based on orthogonal experiment

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Numerical Simulation of Filling Process on Magnesium Alloy Steering Column Bracket

Numerical Simulation of Low Pressure Die Casting of Magnesium Wheel

Numerical Simulation of Isothermal Forging Process of MB26 Magnesium Alloy

Optimization and Design Based On Numerical Simulation of AZ91D Die Casting Gating and Runner System

Numerical Simulation on Compression Casting Process for Copper-Alloy Floor Drain

Numerical Simulation of Gating System for the Die Casting of Magnesium Alloy Steering Wheel

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Progress in numerical simulation of casting process

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical simulation of mould filling and heat transfer of anti-gravity thin-walled casting