Abstract:Sequential extraction techniques have been developed to assess partitioning of anthropogenic radionuclides ((240)Pu, (239)Pu, and (237)Np), originating from a variety of sources, as identified by using bulk sediment isotopic composition. Sediments were leached sequentially with a series of six chemical treatments designed to approximate different environmental processes that may occur or to selectively extract trace metals contained in different solid phases of the sediments (i.e., exchangeable, reducible, carbonate, organic, acid leachable, and refractory). Results indicate the majority of Pu and Np is similarly distributed within many of the extracted fractions, with the largest percentage (66-97%) of both elements being observed in sediments treated with buffered citrate dithionite (CDB), which targets easily reduced constituents such as Mn and Fe hydrous oxides. While these results do indicate an association of Pu and Np with redox sensitive elements, the environmental implications are unclear given that the CDB treatment is more extreme than naturally occurring conditions. Minor amounts of Np partition differently from Pu in sediments. The NH(4)-acetate treatment, which is designed to liberate trace metals that are loosely adsorbed onto the surfaces of sedimentary materials such as hydrated iron oxides and humic substances, or present at exchangeable sites in clay minerals, mobilized approximately 12% of the total Np while Pu levels were below detection. The H(2)O(2) treatment, which is designed to liberate trace metals bound to organic matter, mobilized approximately 8 and approximately 1% of Np and Pu, respectively. These results indicate that a minor portion of the total Np may be affected by environmental conditions that have little or no effect on Pu. Between 7 and 24% of the Pu was observed in treatments designed to liberate Pu and Np that are tightly bound to lithogenic phases or refractory silicates. The (240)Pu/(239)Pu observed in accessible and refractory fractions ranged between 0.11 and 0.18. With the exception of one sample, the (240)Pu/(239)Pu isotope ratios measured in the refractory fractions are essentially identical having a mean ratio value of 0.123+/-0.001 (1sigma). The (240)Pu/(239)Pu ratios provide isotopic evidence that suggests a portion of non-fallout contamination has a refractory nature. The presence of similarly low (240)Pu/(239)Pu ratios in refractory fractions of sediments from the Ob and Irtysh Rivers suggests the existence of a source of refractory Pu which is consistent with refractory "hot particles" derived from surface tests at the Semipalitinsk test site.

Fractionation of Plutonium in Environmental and Bio-Shielding Concrete Samples Using Dynamic Sequential Extraction

Solubility of Pu(Ⅳ)Under Simulated Geological Disposal Condition

Determination of Plutonium Isotopes (238pu, 239pu, 240pu, 241pu) in Environmental Samples Using Radiochemical Separation Combined with Radiometric and Mass Spectrometric Measurements

Determination of Plutonium Isotopes (Pu-238, Pu-239, Pu-240, Pu-241) in Environmental Samples Using Radiochemical Separation Combined with Radiometric and Mass Spectrometric Measurements

Application of a Macroporous Silica-Based CMPO-Impregnated Polymeric Composite in Group Partitioning of Long-Lived Minor Actinides from Highly Active Liquid by Extraction Chromatography

Simultaneous determination of femtogram levels of 237Np, 239Pu, and 240Pu in environmental solid samples using extraction chromatography and ICP-MS/MS

SPEC: A New Process for Strontium and Cesium Partitioning Utilizing Two Macroporous Silica-Based Supramolecular Recognition Agents Impregnated Polymeric Composites

Determination of plutonium isotopes in environmental samples by extraction chromatography with triisooctylamine - polyethylene resin

Using sequential extraction techniques to assess the partitioning of plutonium and neptunium-237 from multiple sources in sediments from the Ob River (Siberia)

Rapid and Simultaneous Determination of 238Pu, 239Pu, 240Pu, and 241Pu in Samples with High-Level Uranium Using ICP-MS/MS and Extraction Chromatography

Rapid Determination of Ultra-Trace Plutonium Isotopes (239pu, 240pu and 241pu) in Small-Volume Human Urine Bioassay Using Sector-Field Inductively Coupled Plasma Mass Spectrometry.

A Rapid Method for Quantification OF 242Pu in Urine Using Extraction Chromatography and ICP-MS

Removal of Plutonium from Contaminated Soil by Chemical Leaching

Highly Selective, exothermic and ligand free separation of plutonium from uranium and americium into ionic liquids

Comparisons of Soil Pretreatment Methods for SF-ICP-MS Determination of Ultra-Trace Level Plutonium in Water Soluble and Exchangeable Fractions

Rapid determination of plutonium isotopes in small samples using single anion exchange separation and ICP-MS/MS measurement in NH3–He mode for sediment dating

Determination of Pu Isotopes in Sediment and Soil Samples by SF-ICP-MS: an Improved Anion-Exchange Procedure for Pu Separation

Co-processing of uranium and plutonium for sodium-cooled fast reactor fuel reprocessing by acid split method for plutonium partitioning without reductant

Rapid Method for Sequential Determination of Pu and Am in Soil and Sediment Samples by Sector-Field Inductively Coupled Plasma Mass Spectrometry

Determination of plutonium in environmental samples by AMS and alpha spectrometry

Comparison for the simultaneous determination of 237Np and Pu isotopes between TEVA and TK200 resin