Preparation of an ASP system using high salinity water from oilfield sewage treated by electrodialysis

KANG Wan-li,NIU Jing-gang,JIA Hong-bing,MENG Ling-wei
DOI: https://doi.org/10.3969/j.issn.2095-4107.2006.02.008
2006-01-01
Abstract:The same volume of fresh water and high salinity water are produced after the oilfield sewage is disposed by electrodialysis. The active diagram of the two ASP systems' interfacial tension is drawn out. The result shows that the alkali concentration range of the high salinity water ASP system to reach the range of ultra low interfacial tension is wider than oilfield sewage ASP system, and alkali concentration range also moves to the direction of the low-alkali(from 0.8%~1.25% of oilfield sewage ASP system to 0.4%~1.0%). But the surfactant ORS-41 concentration range becomes a little smaller (from 0.05%~0.5% of sewage ASP system to 0.1~0.5%). Na_2CO_3 is not fit to make ASP system with high-salinity water. The alkali concentration of high-salinity ASP system is lower than oilfield sewage ASP system by 0.4% in the case of the same polymer and surfactant concentration of the ASP formulation used in oilfield(1 350 mg/L polymer+0.3%surfactant ORS-41+1% alkali ).Using high-salinity water to prepare ASP system not only reduces alkali scale extent,but also makes use of high salinity water. The high salinity ASP system's viscosity is a little higher than oilfield sewage ASP systems'. The results of the microscopic flooding experiment for two ASP formulations by photoengraving model show that the high-salinity and low-alkali-concentration ASP system can flood all kinds of residual oil and improve oil displacement as does the original ASP system.
What problem does this paper attempt to address?