Abstract:It is a fact that a large number of defects such as cracks, voids, inclusions, weak planes, and joint sets are generated within the rock mass during the process of rock formation because of geological-tectonic evolution. The existence of these preexisting natural defects poses potential threats to the stability and safety of structures built on the rock mass. Therefore, it is highly significant to better understand the effects of the preexisting defects on the rock mechanical and fracture behaviors for the stability and safety assessment of rock structures. Uniaxial compression tests were carried out by using ϕ50 mm × 50 mm cylindrical marble specimens with double parallel flaws at end surfaces. When tests were performed, a high speed camera was used to capture the failure processes of the marble specimens. The effects of the flaw length and inclination angle on the mechanical properties and crack propagation of marble specimens were investigated. Further, the experimental results indicate that the uniaxial compressive strength, elastic modulus, and peak strain of the specimen decrease slightly before the flaw length reaches the threshold value. Compared to flaws at vertical angle 90°, flaws at inclined angles (0°<α<90°) of the same length have larger effect on the mechanical properties of marble. It is found from both the experimental and theoretical analysis that cracks usually do not start from the tip of vertical end flaws and most of initiation cracks are developed into dominant cracks. In addition, there are few branches and bifurcations in the crack propagation process, and further, local spalling also occurs at the surface of the specimen. The specimens with inclined flaws exhibit shear failure or combined shear and tensile failure and the ones with vertical end flaws show axial splitting tensile failure. The variation trend of energy consumption parameters is consistent with that of uniaxial compressive strength. It is found that total strain energy of the specimen is positively correlated with its uniaxial compressive strength. Finally, the difference between mechanical and crack propagation processes of marble specimens with end flaws under dynamic and static loads were compared.

Experimental Research on Pre-Cracked Marble under Compression

Experimental and Numerical Study of Strength and Failure Behavior of Precracked Marble under True Triaxial Compression

Experiment and finite element simulation of X-type shear fractures from a crack in marble

Experimental investigation of fatigue crack propagation in interbedded marble under multilevel cyclic uniaxial compressive loads

Effect of the degree of natural cracks development on the mechanical properties of marble

Experimental Study on Cracking Process and Fracture Properties of Granite under Mode I Loading by Acoustic Emission and Digital Image Correlation

Change of Crack Mode in Rock Cracking Process under Quasi-Static and Dynamic Loadings

An Experimental Study of the Strain Field Development Prior to Failure of a Marble Plate under Compression

Fracture Evolution and Failure Behaviour of Marble Specimens Containing Rectangular Cavities under Uniaxial Loading

MINI-CRACK DEVELOPMENT FROM A CEMENTED FRACTURE IN MARBLE SPECIMEN UNDER UNIAXIAL COMPRESSION

Uniaxial Compression Failure and Energy Dissipation of Marble Specimens with Flaws at the End Surface

Experimental and Numerical Investigations on Crack Development and Mechanical Behavior of Marble under Uniaxial Cyclic Loading Compression

Fracture Analysis of Marble Specimens with a Hole under Uniaxial Compression by Digital Image Correlation

Experiment and numerical simulation on cracking behavior of marble containing double elliptic holes under uniaxial compression

Influence of Water on the Fracture Process of Marble with Acoustic Emission Monitoring

Research on the Effect of Cavity Shapes for the Progressive Failure and Mechanical Behavior of Marble

Experimental Research on Crack Propagation and Failure in Rock-type Materials under Compression

Dynamic Strength and Fracturing Behavior of Single-Flawed Prismatic Marble Specimens under Impact Loading with a Split-Hopkinson Pressure Bar

Numerical investigation on the mechanical and fracture behaviors of marble under cyclic loading and unloading true triaxial compression using discrete element method

Experimental Research on Time-Dependent Behavior of Crack Propagation in Jinping Deep Marble

Crack Propagation and Coalescence of Brittle Rock-Like Specimens with Pre-Existing Cracks in Compression