Accident Analysis by Phase-mission Methods in Nuclear Plant

YU Yu,TONG Jiejuan,LIU Tao,ZHAO Jun,ZHANG Aling

DOI: https://doi.org/10.3321/j.issn:1000-7857.2009.15.018

2009-01-01

Abstract:Probabilistic Safety Assessment(PSA) is a systematic engineering evaluation technology,widely used in the nuclear power plant safety evaluation.In PSA,the Event Tree(ET) and Fault Tree(FT) are commonly used.However,it is common that a mission in different phases is executed by different systems or function modules in an engineering project.Conventional ET/FT are static analysis methods based on Boolean logic technology,not flexible enough to handle the dynamic problems directly,e.g.to change the accident scenario evolution at different stages.Sometimes the accurate timing of the events is important for the accident sequence development.The method to evaluate the accident sequence in different phases can be used to solve the problem.The basic idea of this method is to convert the multi-phase system to several single-phase systems to be analyzed separately,and then the results are combined to get the final consequence.Reliability diagram and event tree are two of the important analysis methods for phased analysis.In this paper,they are used to analyze the accident of loss of the main feed water in different phases.It is shown that to improve the reliability of execution process,U1 can help to reduce the probability of core damage in this accident.At last,the applicability of the two methods are discussed briefly.In the reliability diagram,since the real condition of the accident cannot be reflected completely,the illogical cut set should be deleted by hand.In the event tree,since the logical order can be partially reflected,the illogical cut set can be avoided.The two methods are both based on FT or ET eventually,so the accident development with the time cannot be described entirely,and the result is conservative.When the mission time is short,this deviation can be accepted.