Abstract:The extrusion die is one of the most important parts in extrusion processing. It is difficult to design and manufacture to the land length of the die for polypropylene single-lumen micro tubes. In the paper, the land length was designed by rheological properties of polypropylene. For single-lumen micro tubes, the land length with a small air hole was so small that it was easily to be broken, especially in the processing. Therefore, the land length was manufactured by micro-EDM. Then, the experimental results showed that the designed and manufactured die was reasonable and could meet the using requirements. According to the further extrusion experiments, the relationships between tube sizes and extrusion processing parameters were explored. The results indicated that the die temperature had little effect on the tube sizes. That was because the increasing temperature reduced the viscosity and the pressure drop in the die simultaneously. With the given temperature and the constant screw speed, the macromolecules of the polymers with the increasing pulling speeds were straightened to the limit and slipped among the macromolecules, which caused the diameters and wall thicknesses of the micro tubes to decrease in the nonlinear curves. Meanwhile, in the given temperature and the constant pulling speed, the higher the screw speeds got, because of the shear thinning, the smaller the shear viscosity was. However, the increasing amplitudes of the pressure in the die were getting small. So the volume flow rates were also reduced accordingly. Thus the change rates of the diameters and wall thicknesses were also getting small. In the other word, the relations between the micro tube sizes and the screw speeds were not linear, but nonlinear. These results were very valuable for the extrusion die designs of multi-lumen micro tubes and the extrusion processing.

Numerical Simulation and Analysis of the Effects of Compression Angle on Flow Uniformity of Double-chamber Micro-Tube

Numerical simulation for character of fluid flow through packed bed

Numerical Simulation and Experimental Study of Polymer Micro Extrusion Flow

Flow Uniformity of Polymer Micro Extrusion Processing

Numerical Simulation and Analysis of the Effect of Some Materials and Processing Parameters on the Gas Assisted Extrusion of Ultra-high Molecular Weight Polyethylene

FEM Analysis in the Effect of Die Compression Section on Plastic Extrusion Flow

Numerical Analysis of Effect of Channel Structure on Plastic Extrusion Flow

Numerical and Experimental Studies on the Improvement of Gas Chamber Structure During Gas-Assisted Extrusion

Numerical Analysis on Influence of Flow-Resist Rib Structure on Extrusion Flow

Analysis of pressure head during the process of equal channel angular pressing:experiment and simulation

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Influence of Gas Inlet Slit Width on Gas-Assisted Plastic Micro-Tube Extrusion

Numerical and Experimental Analysis of Flow and Distributive Mixing in Cross Section of Screw Channel in Pin Barrel Extruder

Numerical and experimental study on seam welding behavior in extrusion of micro-channel Tube

Numerical Simulation Study Upon Extrusion Forming of Microchannel Tube

Study on design and experiments of extrusion die for polypropylene single-lumen micro tubes

Numerical Simulation of Polishing U-tube Based on Solid-Liquid Two-Phase

Numerical simulation analysis of multi-physical coupling field with abrasive flow precision polishing variable-aperture tube

3-D Non-isothermal Numerical Simulation of the Effect of Temperature Mixing in Mixing Screw Head of Co-Rotating Twin-screw Extruder

Computer Simulation of Extrusion Process of Intermeshing Co-Rotating Twin Screw Extruders

A design method of non-symmetry flowing balance for right angle extrusion die of polymeric double-lumen micro-tube