Abstract:Purpose: The purpose of this study was to investigate the need for high-resolution detailed anatomical modeling to correctly estimate radio-frequency (RF) safety during magnetic resonance imaging (MRI). RF-induced heating near metallic implanted devices depends on the electric field tangential to the device (Etan ). Etan and specific absorption rate (SAR) were analyzed in blood vessels of an anatomical model to understand if a standard gel phantom accurately represents the potential heating in tissues due to passive vascular implants such as stents. Methods: A numerical model of an RF birdcage body coil and an anatomically realistic virtual patient with a native spatial resolution of 1 mm3 were used to simulate the in vivo electric field at 64 MHz (1.5 T MRI system). Maximum values of SAR inside the blood vessels were calculated and compared with peaks in a numerical model of the ASTM gel phantom to see if the results from the simplified and homogeneous gel phantom were comparable to the results from the anatomical model. Etan values were also calculated in selected stent trajectories inside blood vessels and compared with the ASTM result. Results: Peak SAR values in blood vessels were up to ten times higher than those found in the ASTM standard gel phantom. Peaks were found in clinically significant anatomical locations, where stents are implanted as per intended use. Furthermore, Etan results showed that volume-averaged SAR values might not be sufficient to assess RF safety. Conclusion: Computational modeling with a high-resolution anatomical model indicated higher values of the incident electric field compared to the standard testing approach. Further investigation will help develop a robust safety testing method which reflects clinically realistic conditions.

Electromagnetic Effects on the Biological Tissue Surrounding a Transcutaneous Transformer for an Artificial Anal Sphincter System

Biocompatibility and Biosafety Analysis of Transcutaneous Energy Transfer System of Artificial Anal Sphincter

Design and Assessment of Novel Artificial Anal Sphincter with Adaptive Transcutaneous Energy Transfer System

Design of Transcutaneous Energy Transmission System for Artificial Anal Sphincter

Coupling Analysis of Transcutaneous Energy Transfer Coils with Planar Sandwich Structure for a Novel Artificial Anal Sphincter

SMA Artificial Anal Sphincters with Transcutaneous Energy Transmission Systems for Complete Implantation

Safety Study of Implant Wearers in MRI RF Field Environment

Design of planar spiral coil in transcutaneous energy transmission system

An Sma Artificial Anal Sphincter Actuated by Transcutaneous Energy Transmission Systems

Study on Human Safety in Wireless Power Transmission System for Capsule Endoscopy

The State Of Human Bodies In The Electromagnetic Field Based On Wireless Power Transfer Technology

Optimal Design of Litz Wire Coils with Sandwich Structure Wirelessly Powering an Artificial Anal Sphincter System

Effects of dielectric parameters of human body on radiation characteristics of ingestible wireless device at operating frequency of 430 MHz

SIMULATION OF SAR UNDER ULTRA-WIDE BAND ELECTROMAGNETIC PULSE IN HUMAN TISSUE

Adaptive Transcutaneous Power Delivery for an Artificial Anal Sphincter System.

Research on the Technique of Transcutaneous Power Supply For the Artificial Anal Sphincter System

A new method to improve RF safety of implantable medical devices using inductive coupling at 3.0 T MRI

Radio-Frequency Safety Assessment of Stents in Blood Vessels During Magnetic Resonance Imaging

Robust Voltage-Controlled Transcutaneous Energy Transfer System for Artificial Anal Sphincter.

Simulation on the absorbed dose of human tissues in the low frequency strong electromagnetic field

Electromagnetic simulation and electromagnetic safety characteristics analysis of implantable medical devices in wireless charging processes