Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Agglomerating Growth of One-Dimensional Carbon Nano-Materials Synthesized from Ethanol Flames

Single-Crystalline Dendritic Bimetallic And Multimetallic Nanocubes

Growth and Characterization of Bamboo-Like Multiwalled Carbon Nanotubes over Cu/Al2o3 Catalyst

In situ flame-synthesis of nanostructured carbon materials via facile alcohol Bunsen burner

In-Depth Understanding of the Morphology Effect of α-Fe2O3 on Catalytic Ethane Destruction

In-Situ Flame-Synthesized Carbon Nanomaterials via an Impinging Swirl Flow with an N-Butanol Pool

Tailoring C─N Containing Compounds into Carbon Nanomaterials with Tunable Morphologies for Electrocatalytic Applications

Agglomerated CNTs Synthesized in a Fluidized Bed Reactor: Agglomerate Structure and Formation Mechanism

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Selective Preparation of Carbon Nanoflakes, Carbon Nanospheres, and Carbon Nanotubes Through Carbonization of Polymethacrylate by Using Different Catalyst Precursors

Mechanism of alcohol chemical vapor deposition growth of carbon nanotubes: Catalyst oxidation

Experimental research on flame synthesis of carbon nanotubes and its growth mechanism analysis

Shape-Controlled Growth of Carbon Nanostructures: Yield and Mechanism

Nano Palladium-Based Catalysts by Flame Synthesis and Catalytic Ignition

Flame Synthesis of Novel Ternary Nanocatalysts Pd/CeO2TiO2 with Promotional Low-Temperature Catalytic Oxidation Properties

Hybrid tungsten-carbon 2D nanostructures via in situ gasification of carbon substrates driven by ebeam irradiation of WO2.9microparticles

Morphological Changes of Nano-Al Agglomerates During Reaction and Its Effect on Combustion

Stepwise carbonization of nanocellulose to N-doped carbons with structural transformation and enhanced peroxymonosulfate activation

Effect of Oxygen Concentration on Soot Morphology in C2H4 Diffusion Flame

Morphology‐Engineering Construction of Anti‐Aggregated Co/N‐Doped Hollow Carbon from Metal‐Organic Frameworks for Efficient Biomass Upgrading

Boosting Catalytic Combustion of Ethanol by Tuning Morphologies and Exposed Crystal Facets of α-Mn2O3