Abstract:Electrochemically controlled solid-phase extractions of anions were interfaced on-line to electrospray mass spectrometry (ESI-MS) and inductively coupled plasma mass spectrometry (ICP-MS), using polypyrrole coated electrodes and a thin-layer electrochemical (EC) flow cell. The results indicate that electrochemically controlled solid-phase extraction (EC-SPE) can be used as a versatile potential controlled sample preparation technique for a range of anions and that the properties of the polypyrrole coatings can be modified by altering the electrodeposition conditions. In the present study, the influence of interfering anions (i.e., fluoride and sulfate), and the anion used during the electropolymerisation, on the bromide extraction recovery was investigated for EC-SPE interfaced to ICP-MS. The results of these experiments show that the interference due to the presence of similar concentrations of sulfate can be reduced when using a polypyrrole coating electropolymerised in the presence of bromide ions. Scanning electron microscopy (SEM) and atomic force microscopy (AFM) measurements were also used to study the morphology of the coatings, as well as the variations in the film thickness within the coatings. The effect of different desorption techniques on the bromide preconcentration factor in the ICP-MS on-line flow system was also examined. Stopped-flow desorption was found to give rise to significantly increased preconcentration factors in comparison with desorptions in flowing solutions. While the desorption efficiency depends on the type of desorption electrolyte (the electrolyte in which the desorption takes place), due to the competing influx of cations, the influence of the pH on the switching charge of the polypyrrole coating was found to be small, at constant ionic strength. To study the applicability of the EC-SPE technique with respect to real samples, investigations were also made with tap water samples spiked with different bromide concentrations. The results of these experiments, which were carried out using a modified thin-layer EC flow cell allowing in situ polymerisation of polypyrrole yielding a polymer plug covering the cross section of the channel, demonstrate that 3 microM concentrations of bromide could be detected in the tap water sample. This demonstrates that the extraction technique allows extractions of low concentrations of ions in the presence of significantly higher concentrations of other similar ions. The fact that the extraction and desorption steps are electrochemically controlled makes EC-SPE particularly well suited for inclusion in miniaturised lab-on-a-chip systems.

Electrically Controlled Anion Exchange Based on Polypyrrole and Carbon Nanotubes Nanocomposite for Perchlorate Removal.

Electrically Controllable Perchlorate Removal Based on Poly(Aniline-Co-O-Aminophenol) Doped with P-Toluene Sulfonate

One-step Electrospinning of Negatively-Charged Polyethersulfone Nanofibrous Membranes for Selective Removal of Cationic Dyes

Smart Cationic Coordination Polymer: A Single-Crystal-to-single-crystal Approach for Simultaneous Detection and Removal of Perchlorate in Aqueous Media

Film electrode by incorporating polypyrrole/carbon black into cross-linked binders of chitosan/cationic polyacrylamide for selective chloride extraction in wastewater

Selective separation of monovalent anions by PPy/pTS membrane electrodes in redox transistor electrodialysis

Flexible and free-standing pristine polypyrrole membranes with a nanotube structure for repeatable Cr(VI) ion removal

Preparation, Characterization and Anion Exchange Properties of Polypyrrole/Carbon Nanotube Nanocomposites

Electrically Redox-Active Membrane with Switchable Selectivity to Contaminants for Water Purification.

Potassium-Ion Recovery With A Polypyrrole Membrane Electrode In Novel Redox Transistor Electrodialysis

Fabrication of an Efficient Hierarchical Mesoporous 2D-Mos2/cnt/polypyrrole Based Composite Electrodes for Competitive and Selective U6+ Removal Using Capacitive Deionization: Mechanistic Evaluation Through Cyclic Voltammetry

Fabrication of an efficient hierarchical mesoporous 2D-MoS 2 /CNT/polypyrrole based composite electrodes for competitive and selective U 6+ removal using capacitive deionization: Mechanistic evaluation through cyclic voltammetry

Capacitive Organic Dye Removal by Block Copolymer Based Porous Carbon Fibers

Mechanism Study of Selective Heavy Metal Ion Removal with Polypyrrole-Functionalized Polyacrylonitrile Nanofiber Mats

Novel Hybrid Materials for Electrically Switched Ion Exchange: Carbon Nanotubes/Polyaniline/Nickel Hexacyanoferrate Films

Preparation of MOF/polypyrrole and flower-like MnO2 electrodes by electrodeposition: High-performance materials for hybrid capacitive deionization defluorination

Bromate removal from water by polypyrrole tailored activated carbon.

On-line electrochemically controlled solid-phase extraction interfaced to electrospray and inductively coupled plasma mass spectrometry

Electrically Pore‐Size‐Tunable Polypyrrole Membrane for Antifouling and Selective Separation

Pseudocapacitive Behaviors of Polypyrrole Grafted Activated Carbon and MnO2 Electrodes to Enable Fast and Efficient Membrane-Free Capacitive Deionization.

Scalable Conductive Polymer Membranes for Ultrafast Organic Pollutants Removal