Design and Experimentation of High-Pressure Water Jet Set Applied to Incising Coal Seam in Boreholes

Tang Jian-xin,Jia Jiang-qing,Hu Guo-zhong,Wang Hong-tu,Li Xiao-hong,Hu Guang-lin
DOI: https://doi.org/10.3969/j.issn.1000-7598.2007.07.041
2007-01-01
Abstract:In allusion to the problems of the low gas-penetration and low ratio of gas drainage during draining gas and prevention outburst, it is designed the high-pressure water jet installation of cutting coal which is installed in the draining bore, and tested the nozzle and the ejector in scene. The result showed that the effect of the coal cut by high-pressure water jet is the best when the angle of water jet is + 100, the diameter of nozzle is 1.5mm, the cutting speed is 0.2m/min and the pressure of the pump is 30MPa; it is showed that the draining ratio is raised about 18.8% and the draining time is shorten over 90% when the coal is cut by the high-pressure water jet, too. Therefore, the technology is very important to the draining gas and preventing outburst.
What problem does this paper attempt to address?