Abstract:<p>Rock engineering projects at depth are frequently subjected to dynamic loadings under <em>in-situ</em> stress state, and the studies should be conducted to decipher the coupled effect of confining pressure and strain rate on the behaviour of rocks. The triaxial Hopkinson bar system has been applied to investigate the responses of materials to the coupled multiaxial static-dynamic loads. In this study, a three-dimensional (3D) continuum-discrete coupled method is employed to establish a numerical-based triaxial Hopkinson bar system, and the steel bars and a cubic specimen are modelled by continuum zones and bonded-particle material, respectively. Firstly, the detailed numerical modelling is performed to verify some prerequisites and uncertainties in the experiments, including stress wave propagation and attenuation in three directions, dynamic stress equilibrium, boundary effects, interfacial frictions, and controversial methodologies for applying confining pressure, by using the flat-joint model and parallel bond model. Then, both experimental tests and numerical modelling are carried out on sandstone under multiaxial pre-stress conditions (i.e., uniaxial, biaxial and triaxial compression) followed by dynamic loads. The dynamic responses of rock, including stress-strain curves, dynamic strength, energy evolutions, and damage patterns, exhibit confinement dependence, which is in good agreement with experimental observations. Under uniaxial compression, the specimens are broken into fragments by multiple fractures; while under biaxial compression, two symmetrically distributed V-shaped damage zones form near the free surfaces. Under triaxial compression, the degree of damage is substantially reduced, and microcrack localisation zones are initiated from the surface, propagate to the interior and eventually form macroscopic fractures. Moreover, a series of numerical simulations is conducted to investigate the strain rate dependence of sandstone under multiaxial load conditions. Both dynamic strength and peak lateral dynamic stresses increase with increasing strain rate. The increase of dynamic strength and failure strain becomes obvious at high strain rates with the enhancement of lateral confinement.</p>

Numerical Modeling of the Effect of Strain Rate on the Stress-Strain Relation for Soft Rock Using A 3-D Elastic Visco-Plastic Model

Biaxial Creep Test Study on the Influence of Structural Anisotropy on Rheological Behavior of Hard Rock

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

An experimental investigation and mechanical modeling of the combined action of confining stress and plastic strain in a rock mass

Modeling Strain-Rate Dependent Behavior of KR0-Consolidated Soft Clays

An Elastic-Viscoplastic Model for Time-Dependent Behavior of Soft Clay and Its Application on Rheological Consolidation

A nonlinear constitutive model for whole stress–strain behaviors of compressed rocks incorporating crack closure effect

An extended super/subloading surface model for soft rock considering structure degradation

Numerical Simulation on the Effect of Rock Joint Roughness on the Stress Field

3D continuum-discrete coupled modelling of triaxial Hopkinson bar tests on rock under multiaxial static-dynamic loads

An experimental study of mechanical behavior of brittle rock-like specimens with multi-non-persistent joints under uniaxial compression and damage analysis

Experimental and constitutive model study on the mechanical properties of a structural plane of a rock mass under dynamic disturbance

A Numerical Study of the Mechanical Behavior of Jointed Soft Rocks under Triaxial Loading Using a Bonded Particle Model

A three-dimensional elastoplastic constitutive model incorporating Lode angle dependence

Dynamic triaxial constitutive model for rock subjected to initial stress

A Visco-Hyperelastic Softening Model for Predicting the Strain Rate Effects of 3D-Printed Soft Wavy Interfacial Layer

Melt flow and mechanical properties of silica/perfluoropolymer nanocomposites Fabricated by direct melt-compounding without surface modification on nano-silica.

A Damage Constitutive Model for a Jointed Rock Mass under Triaxial Compression

A unified hardening/softening elastoplastic model for rocks undergoing brittle-ductile transition with strength-mapping and fractional plastic flow rule

A Strain Hardening Model for the Stress-Path-dependent Shear Behavior of Rockfills

The strain characteristics and corresponding model of rock materials under uniaxial cyclic load/unload compression and their deformation and fatigue damage analysis