Abstract:The results of an experimental study of the processes of ion exchange sorption and desorption of copper and zinc ions on a composite sorbent are presented. The sorbent is obtained from modified sawdust and chitosan at a molar ratio of 1 : 0.4. The average particle size is 1.6 mm. The sorbent has a macroporous structure and contains carboxyl, phenolic hydroxyl groups and amino groups capable of ion exchange with heavy metal ions from solutions. The experimental study is а passing the initial solution through a stationary annular sorbent layer and reading the output curves of ion exchange. The sorbent with a volume of 9.8×10 –4 m 3 was placed in an annular adsorber between the inner and outer gratings. In the study of the direct ion exchange process, solutions of copper and zinc sulfates with a concentration of 0.05 N with volume velocity 8.1×10 –6 m 3 /s and a sorbent in Na- form were used. Sorbent was regenerated from heavy metal ions with 0.08 N sodium hydroxide solution with volume velocity 3.2×10 –6 m 3 /s. The full exchange capacities of the sorbent, the degree of regeneration of the sorbent and the specific consumption of the regeneration solution were calculated based on the output curves of ion exchange. The analysis of experimental data showed a decrease in the exchange capacity of the sorbent during its repeated use. After five sorption-desorption cycles, the value of the total dynamic exchange capacity of the sorbent decreased for copper ions by 30% and for zinc ions by 25%. The decrease in the exchange capacity is associated with a decrease in the amount of carboxyl and phenolic hydroxyl groups in the sorbent, as well as with the compaction of its structure and, consequently, a decrease in the availability of functional groups.

Chromatographic Zinc Isotope Separation by Chelating Exchange Resin

Zinc Isotope Separation by Phenol Formaldehyde Type 15-Crown-5 Resin in Organic Solvents

Zinc Isotope Separation in Acetone by Displacement Chromatography Using Benzo-15-Crown-5 Resin

Chromatographic zinc isotope separation by phenol formaldehyde benzo crown resin.

Zinc Isotope Effects in Benzo Crown Resin by Displacement Chromatography

Preconcentration and Separation of Zn2+ Using Surface Zinc(Ii) Imprinted Functionalized Silica Gel Sorbent

A Study on Zinc Isotope Fractionation in A Benzo Crown Resin/Acetone System

DFT and MD simulation supplemented experiments for isotopic fractionation of zinc compounds using a macrocyclic crown ether appended polymeric resin

Kinetics of zinc ions removal from effluents using ion exchange resin

Zinc Isotope Fractionation During Sorption Onto Al Oxides: Atomic Level Understanding from EXAFS.

Direct separation of Zn from dilute aqueous solutions for isotope composition determination using multi-collector ICP-MS

Removal of Zn(II) from Manganese-Zinc Chloride Waste Liquor Using Ion-Exchange with D201 Resin

Chromatographic Separation of Cd from Plants Via Anion-Exchange Resin for an Isotope Determination by Multiple Collector ICP-MS.

Effects of Cross Linking on the Chromatographic Nitrogen Isotope Separation

Determination of zinc in plant samples by isotope dilution inductively coupled plasma mass spectrometry

Chromatographic Separation and Recovery of Zn(II) and Cu(II) from High-Chlorine Raffinate of Germanium Chlorination Distillation

Selective Solid-Phase Extraction of Zn(II) by An Ion-Imprinted Polymer from Environmental and Biological Samples

Improvements in Cu–Zn Isotope Analysis with MC-ICP-MS: A Revisit of Chemical Purification, Mass Spectrometry Measurement and Mechanism of Cu/Zn Mass Bias Decoupling Effect

Separation and preconcentration of perrhenate from ionic solutions by ion exchange chromatography

Processes of Ion Exchange Sorption and Desorption of Cu2+ and Zn2+ Ions on a Composite Sorbent

Chelation Rate of Zinc Amino Acid Chelate Determined by Sephadex Gel Filtration Chromatography