Abstract:Satellite communications are a well-established research area in which the main innovation of last decade has been the use of multi-carrier modulations and more robust channel coding techniques. However, in recent years, novel advanced signal processing has started being developed for these communications due to the increase in the signal processing capacity of transmitters and receivers. Although signal processing capabilities are increasing, they are still constrained by large limitations because these techniques need to be implemented in real hardware, thus making complexity a matter of critical importance. Therefore, this paper presents the design and implementation of a transmitter with adaptable coding and modulation on a field-programmable-gate-array (FPGA). The main motivation came from the standard CCSDS 131.2-B-1 which recommends that such a novel transmitter which has to date not been implemented in a real system The system was modeled by MATLAB with the purpose of being programmed in VHDL following the AXI-stream protocol between components. Behavioral simulation results were obtained in VIVADO and compared with MATLAB for verification purposes. The transmitter logical circuit was synthesized in a FPGA Zynq Ultrascale RFSoC ZU28DR, showing low resource consumption and correct functioning, leading us to conclude that the deployment of new communication systems in state-of-the-art hardware in satellite communications is justified.

Implementation of Channelized Transmitter Based on FPGA

Implementation of Muiti-channel HDLC Protocol Based on FPGA

Research and implementation of digital channelized receiver based on FPGA

Design and implementation of direct sequence spread spectrum transmitter based on FPGA

Implementation of Adaptive Equalizer with FPGA

Design and Implementation of Digital Channelized Receiver in Multi-FPGA

CCSDS 131.2-B-1 Transmitter Design on FPGA with Adaptive Coding and Modulation Schemes for Satellite Communications

Design and Implementation of a MSK Modulator Based on FPGA

Design of Multi-channel Signal Simulator Based on ARM and FPGA

A Real-time Digital Channel Simulator Using DSP+FPGA

Channelized receiver based on FPGA

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

Design and FPGA Implementation of a Reconfigurable 1024-Channel Channelization Architecture for SDR Application.

Design of Millimeter-wave Transmitter Based on FPGA

Channel Filter Algorithm Based on Polyphase Structure with Bandpass Filters

Wideband Digital Channelized Parallel Architecture and Its FPGA Implementation

FPGA Implementation of a Reconfigurable Channelization for Simultaneous Multichannel DRM30/FM Receiver.

Research and Design of Multi-Channel Telemetry Signal Digital Baseband Transmitter and Receiver Module

FPGA Implementation of Sideband Distortion Suppression for Millimeter Wave Transmitter at Q-band

Design and implementation of transmitter module in 40 Gbit/s very short reach optical transmission system

Modeling and Implementing for Mobile Radio Fading Channel in IF Based on FPGA