Voltage Endurance Characteristics of Cross-linked Polyethylene-Silicone Rubber Interface Subjected to DC and AC Voltages
Xiaodong Li,Hao Hu,Kairun Song,Zhengxue Wang,Zhidong Jia
DOI: https://doi.org/10.1109/tdei.2024.3456773
IF: 2.509
2024-01-01
IEEE Transactions on Dielectrics and Electrical Insulation
Abstract:When designing and inspecting power equipment, it is crucial to consider not only the distinctions between AC, DC, and AC-DC hybrid systems, but also the voltage endurance characteristics. However, scientific design and research on the mechanism responsible for the breakdown of solid-solid interfaces (e.g., cable joints), which are weak points in electrical insulation, is lacking. Therefore, in this study, the insulating strength of the interface in relation to the electric field form and voltage endurance time is examined. Specifically, the increase in the insulation strength and the ablation of a cross-linked polyethylene-silicone rubber (XLPE-SiR) interface were investigated based on the ramped breakdown and step-stress methods. The results revealed that the DC breakdown strength surpassed the AC breakdown strength, and the AC field failed to reach the composite (AC-DC) electric field breakdown strength. Furthermore, the interfacial breakdown strength was influenced by both long-term and transient stresses. Moreover, the interfacial breakdown process could be divided into three stages. The breakdown voltage increased in the short term with decreasing step-up rate. Step-stress tolerance experiments and simulations indicated that the highly distorted electric field at the asperity contacts led to cavity discharges and electrothermal losses, which resulted in the ablation of the asperities on the rough surface. As the interface roughness decreased, the electric field distortion decreased, which increased the breakdown strength. Moreover, as the endurance time increased, the improvement of the AC breakdown strength was more significant than that of the composite electric field, and the improvement of the DC breakdown strength was the smallest.