Study on Process Parameters of Oily Sludge Washing

Sun Junxiang,Wang Dong,Li Yichuan
DOI: https://doi.org/10.3969/j.issn.1007-3426.2008.03.020
2008-01-01
Abstract:Oily sludge of Liao River Oil field is adopted as the sample for soil purification and petroleum recovery by thermochemical washing to obtain the essential parameters for engineering project.As the results indicated,after agitating for 30 minutes at 65℃ with agitation speed at 200r/min,solid-to-liquid ratio at 1:6,pH value at 9 and LAS-Na2SiO3 built detergent concentration at 3.3g/L(mass ratio 1:2),the residual oil rate for sample which contains 21.2% oily sand is 0.3%.After cleaning,petroleum floated on the surface of water without obvious emulsification and is easily separated.Based on the specific requirements of residual oil rate,thermochemical washing system can adjust the gradation of cleaning unit and cycling times of washing solution and simplify technological process.As for the waste water in flocculation treatment,COD reduced to 115mg/L when we use 1.2g/L PFS and 30mg/L CPAM.Factors such as temperature,pH value,solid-to-liquid ratio,detergent concentration,etc.which contribute to oil washing efficiency are taken into consideration to optimize technological parameters by orthogonal experiment.
What problem does this paper attempt to address?