Abstract:Abstract With the advancement of the manufacturing industry, there is a growing need for high-speed five-axis machine tools that offer superior precision. Current research indicates that with the increase in the feed rate of machine tools, the influence of machine tool dynamic performance on precision becomes increasingly significant. In addition to the tracking performance of a single machine axis system, the servo dynamics matching degree (SDMD) between each machine axis system has also been widely recognized as one of the important factors affecting the dynamic performance in recent research. As an ISO standard specimen, the S-specimen has emerged as the frequently utilized specimens for machine tool acceptance testing, owing to its capacity to better reflect the dynamic performance of five-axis machine tools. Nevertheless, the intricate mapping relationship between the factors influencing SDMD and the contour error of the S-specimen constrains the applicability of this standard specimen in error diagnosis and subsequent dynamic performance optimization. Therefore, based on the machining process of the S-specimen, a dynamic performance optimization method by improving SDMD was proposed in this paper. An index of SDMD between two machine axis systems (two-axis SDMDI) was established which clarifies the specific source for error diagnosis. A calculation model of the two-axis SDMDIs of five-axis machine tool was established based on the mapping relationship between the index and the contour error of S-specimen which provided an effective way for optimization of SDMD based on S-specimen machining test. Experiments were carried out to verify the effectiveness of the proposed optimization method.

Servo Parameters Tuning for SINUMERIK 840D and 611D

A Novel Three-Parameter Tuning Method For Seismic Simulation Shaking Table

METHOD OF SERIAL CONTROL TO IMPROVE DYNAMIC RESPONSE OF THE ELECTRO-HYDRAULIC POSITION SERVO SYSTEM

Design and Integration Technology of Communication System of Finish Machining for Aircraft Fuselage-Wing Joints

Identification of Characteristic Parameters and Structure Parameters in Pneumatic Servo Control

The Parameter Identification Method of Steam Turbine Nonlinear Servo System Based on Artificial Neural Network

Servo Performance Improvement Through Iterative Tuning Feedforward Controller with Disturbance Compensator

Experimental Study on SMC Series Cylinder of CE1 Pneumatic Servo System

Investigation of the Controller Parameter Optimisation for A Servomechanism

Two-Dof Speed Control Of Permanent Magnet Synchronous Machine With A Novel Parameter Identification Method

Dynamic performance optimization of five-axis machine tools based on S-specimen and servo dynamics matching degree indexes

A Satisfactory Sets Research Of Design-Parameters On A Certain Servo System

Parameters Self-Tuning and Optimization of Speed PI Controller for PMSM Servo System

The Analysis and Optimization of Machining Precision Based on Electromechanical Matching in High-Speed Machine Tools

Inertia and Auto-Tuning of Speed Controllers for AC Servo Systems

STUDY ON THE HIGH PERFORMANCE LINEAR SERVO SYSTEM FOR MIDDLE-CONVEX AND VARYING ELLIPSE PISTON MACHINING

Research on servo matching of a five-axis hybrid machine tool

Optimisation of the Micro and Small Hole EDM Process Based on the Experimental Design

An investigation on discharge servo parameters and machining servo mode optimization of MS-WEDM

Model Parameter Identification of NC Machine Planar Motor Servo System Based on Adaptive Digital Sliding Mode Control

A New Method of Simulation and Development for Digital Controlled AC Servo System