Abstract:Hydraulic models have been widely used to facilitate the design, management, and operation of water distribution systems (WDS). However, model parameters including pipe roughness coefficients (PRCs) and nodal demands (NDs) must be calibrated before practical applications, and the calibration accuracy and efficiency is important to enable their wide uptake in practice. This therefore motivates intensive studies to develop approaches for model calibration focusing on either optimization algorithms or numeric methods. Although these previous studies have advanced this research area, the calibration efficiency and effectiveness need to be further improved, especially when dealing with real-world problems. To attain this objective, this paper proposes an efficient numerical approach to simultaneously calibrate PRCs and NDs for WDS. Within this method, the calibration objective function is formulated as a least-square equation, followed by the derivation of iterative formulas according to a local sensitivity analysis. These formulas allow PRCs and NDs to be iteratively updated in an efficient manner until the given convergence criteria are met. To further improve the efficiency, the pipes and nodes are grouped according to their physical properties, which allows the calibration dimensions to be significantly reduced. Additionally, within the calibration process, values of PRCs and NDs are restricted into specified ranges to ensure the calibrated results are practically meaningful. Two case studies are used to demonstrate the utility of the proposed method, and results show that this approach is able to simultaneously calibrate PRCs and NDs efficiently, with the modeled hydraulic parameter values (pipe flows and nodal pressures) matching well with observations.

3-D numerical calculation method of nozzle flow rate for water distribution pipe in cooling tower

2-D numerical method for simulating complex flow field

Three-dimensional Numerical Study on Water-Distribution Optimization in a Natural Draft Wet Cooling Tower

Efficient Numerical Approach for Simultaneous Calibration of Pipe Roughness Coefficients and Nodal Demands for Water Distribution Systems

Numerical investigation on novel water distribution for natural draft wet cooling tower

Three-dimensional numerical simulation on thermal performance in counter flow natural draft cooling tower

Three-dimensional Numerical Analysis on a New Design of Hydraulic Structure for Water Treatment

Three-Dimensional Numerical Study on Thermal Performance in A Natural Draft Wet Cooling Tower

Three-dimensional Numerical Study on Thermal Performance of a Super Large Natural Draft Cooling Tower of 220m Height

Numerical simulation on synergetic optimization of non-equidistant fillings and non-uniform water distribution for wet cooling towers

Numerical Study on Water Distribution of Natural Draft Wet Cooling Towers under Crosswind

Numerical Simulation of Inlet and Outlet Passages for Axial Flow Pump in Drainage Pump Station

Numerical Simulation and Optimization of Internal Flow Field in the High Pressure Coal Conveying Pump Based on the Dynamic Mesh

Numerical Simulation of the 3-D Turbulent Flow in the Water Inhaling Pipes and the Sump of the Pump

3D Temperature Evaluation of the Vane Based on Fluid-Network Method

Experimental study and 3-D numerical simulation on water flow in Y-type pipe

Numerical Simulation of 3D Flow Field and Temperature Field Near Dam Area of Three-Gorges Reservoir

Research on Heat and Mass Transfer Performance of Corrugated Coils in Closed Cooling Towers

Numerical Method for Coolant Mixing in Turbine Cascade Flow Field

Numerical Study of Natural Draft Wet Cooling Tower

Numerical Study of the Thermal Performance in Natural Draft Wet Cooling Tower with Different Fill Types