Abstract:BackgroundSurfactants are widely used across the globe both in industrial and consumer products. The n-octanol/water partition ratio or coefficient (log Kow) and n-octanol/water distribution coefficient (log D) are key parameters in environmental risk assessment of chemicals as they are often used to estimate the environmental fate and bioavailability and thus exposure and toxicity of a compound. Determining log Kow data for surfactants is a technical challenge due to their amphiphilic properties. Currently several existing experimental OECD methods (e.g. slow-stirring, HPLC, solubility ratio) and QSPR models are available for log Kow/D measurement or prediction. However, there are concerns that these methods have not been fully validated for surfactants and may not be applicable due to the specific phase behaviour of surfactants.ResultsThe current methods were evaluated for the four surfactant classes (non-ionic, anionic, cationic and amphoteric). The solubility ratio approach, based on comparative n-octanol and water solubility measurements, did not generate robust or accurate data. The HPLC method generates consistently higher log Kow values than the slow-stirring method for non-ionics, but this positive bias could be removed using reference surfactants with log Kow values determined using the slow-stirring method. The slow-stirring method is the most widely applicable experimental method for generating log Kow/D data for all the surface-active test compounds. Generally, QSPR-predicted log Kow/D values do not correlate well with experimental values, apart for the group of non-ionic surfactants. Relatively, large differences in predicted log Kow/D values were observed when comparing various QSPR models, which were most noticeable for the ionised surfactants.ConclusionsThe slow-stirring method is the most widely applicable experimental method for generating log Kow/D data for all the four surfactant classes. A weight of evidence approach is considered appropriate for non-ionic surfactants using experimental and model predications. However, it is more difficult to apply this approach to ionisable surfactants. Recommendations are made for the preferred existing QSPR predictive methods for determination of log Kow/D values for the surfactant classes. Investigation of newer alternative experimental log Kow methods as well as more biologically relevant and methodologically defensible alternative methods for describing partitioning of surfactants are recommended.

Calculating partition coefficient by atom-additive method

A New Atom-Additive Method for Calculating Partition Coefficients

A New Method for Calculating Partition Coefficients of Organic Compounds

Computation of octanol-water partition coefficients by guiding an additive model with knowledge.

A New Model for Calculating Logp for Organic Compounds

Calculating Partition Coefficients of Peptides by the Addition Method

An Empirical Additive Model for Aqueous Solubility Computation: Success and Limitations

Developing the QSPR Model for Predicting the Storage Lipid/water Distribution Coefficient of Organic Compounds

The Octanol-Water Partition Coefficient: The Effect of Electronic Interactions

The Octanol-Water Partition Coefficient:The Effect of Electronic Interactions

Computational Approaches to Estimating Octanol-Water Partition Coefficient and Water Solubility of Organic Compounds

Dimensionally reduced machine learning model for predicting single component octanol-water partition coefficients

Octanol/water partition coefficients estimated using retention times in reverse-phase liquid chromatography and calculated in silico as one of the determinant factors for pharmacokinetic parameter estimations of general chemical substances

Calculating the Partition Coefficients of Organic Solvents in Octanol/Water and Octanol/Air

ADME Evaluation in Drug Discovery. 4. Prediction of Aqueous Solubility Based on Atom Contribution Approach

Comparison of Four Methods of Predicting Newly Measured Octanol/water Coefficients (log Kow) for Heterocyclic Nitrogen Compounds and the Partition Mechanism

Effect of Atomic Charges on Octanol–Water Partition Coefficient Using Alchemical Free Energy Calculation

ADME Evaluation in Drug Discovery. Part 2. Prediction of Partition Coefficient by Atom‐Additive Approach Based on Atom‐Weighted Solvent Accessible Surface Areas.

Development and Test of Highly Accurate Endpoint Free Energy Methods. 2: Prediction of Logarithm of N‐octanol–water Partition Coefficient (logp) for Druglike Molecules Using MM‐PBSA Method

Estimation of N‐octanol/water Partition Coefficients (kow) of All PCB Congeners by Ab Initio and a Cl Substitution Position Method

A comparison of log Kow (n-octanol–water partition coefficient) values for non-ionic, anionic, cationic and amphoteric surfactants determined using predictions and experimental methods