The transition conditions of supershear rupture propagation on fault-bend systems
Zheng LingLong,Qian Feng,Zhang HaiMing
DOI: https://doi.org/10.6038/cjg202100115
2021-01-01
Abstract:The rupture speed on the fault during an earthquake is an important physical quantity to describe the earthquake source process. The seismic wave field would be affected, which possibly creates much more severe damage, if the propagation speed of the rupture exceeds the shear wave velocity. The occurrence of supershear rupture is controlled by many factors, one of which is the fault geometry. In this paper, we focus on the fault geometry with a bending angle. By adopting the boundary integral equation method based on the three-dimensional unstructured grids, we are able to calculate the rupture phase diagram in the parameter space, and analyze the transition conditions of supershear rupture. Taking 15 degrees, 25 degrees and 40 degrees as examples, phase diagrams under different bending angles are obtained. Under the initial stress setting of this study, by cross-comparing the results on different combinations dimensionless critical slip weakening distance (D) over bar (c) and initial shear stress (T) over bar (e), we find that for fault models with bending planes in the compression zone, the generation of the unsustainable self-arresting ruptures is independent of the bending angle. Similarly, for the sustainable ruptures, the propagation speed on the planar part of the fault is also not affected by the bending angle. At the bending line, however, the rupture speed will reduce with the increase of the bending angle. And the greater the normal stress, the greater the fracture strength is, and the harder it is to propagate beyond the bending line (e.g., 40 degrees). Comparing the three phase diagrams, it is easier to generate the supershear rupture when the bending angle is small, in other words, the corresponding parameter space is larger for a smaller bending angle. Moreover, with the increase of initial shear stress, supershear rupture can occur not only on the bending plane, but also on the planar part. In general, when (D) over bar (e) is small and (T) over bar (e) is large, the rupture propagation speed is large, which is more prone to generate supershear rupture. In addition, the delay effect caused by overcoming the normal stress is also positively related to the bending angle.