Abstract:Recently, medium-entropy alloys (MEAs) combining high hardness with excellent ductility have attracted numerous attentions. Here we synthesize a series of Co-Ni-V-Al MEA thin films by magnetron sputtering at room temperature with deposition power from 60 W to 300 W. The film microstructure, morphology, and mechanical properties depended remarkably on atomic fluence, proportional to deposition power. With increasing atomic fluence, the amorphous phase fraction experienced a process of first decreasing and then increasing, and fully amorphous structure was obtained at 300 W. Surface diffusion is dominated in low incident atomic energy range, while deposition rate effect is dominant over surface diffusion effect in high incident atomic energy range, resulting in the crossover in phase selection. The nanocolumn size increased with atomic fluence from 60 W-films to 150 W-films, accompanied by roughness rise, and remained constant with further increasing atomic fluence, along with roughness drop caused by fully amorphous structure. Excellent mechanical properties including higher hardness, tensile fracture strength, lateral Young's modulus, better scratch-resistance, lower coefficient of friction, were observed for higher incident atomic energy films. In low atomic fluence range from 60 W-films to 150 W-films, the improved mechanical response mainly come from the reduced fraction of interfacial region between adjacent nanocolumns. Further increasing atomic fluence, it is the bombardment-induced dense nanocolumn boundaries, rather than enhanced adatom diffusion at high atomic fluence, that cause further improved mechanical response. Our current work could pave a way for a controlled synthesis of high-performance MEA thin films via tuning deposition power. (c) 2021 Elsevier B.V. All rights reserved.

Surface Characteristics and Nanoindentation Study of Ni–Mn–Ga Ferromagnetic Shape Memory Sputtered Thin Films

Structural, Magnetic and Mechanical Properties of Oligocrystalline Ni-Mn-Ga Shape Memory Microwires

Study of Nanocrystalline Fe-Al-N Soft Magnetic Thin Films

Structural Modulations and Magnetic Properties of Off-Stoichiometric Ni-Mn-Ga Magnetic Shape Memory Alloys

Deposition and nanoindentation study of a novel TiNi/Ag bi-layer shape memory film

Microstructure Characterization, Structure and Magnetic Properties of Ni–Mn–Sn Shape Memory Alloys

Microstructure and magnetocaloric effect in nonequilibrium solidified Ni-Mn-Sn-Co alloy prepared by laser powder bed fusion

Manipulation of microstructure evolution and deformation behavior in Ni–Mn–Ga shape memory alloys with varied Ni/Ga under uniaxial cyclic compression

MECHANICAL PROPERTIES OF NiTi SHAPE MEMORY THIN FILMS

The Martensitic Transformation, Magnetocaloric Effect, and Magnetoresistance in High-Mn Content Mn47+xNi43−xSn10 Ferromagnetic Shape Memory Alloys

Influence of microstructure on elastocaloric and shape memory effects in Mn50Ni32Sn7Co11 alloys

Enhanced Elastocaloric Effect and Mechanical Properties of Fe-doped Ni–Mn–Al Ferromagnetic Shape Memory Alloys

First-principles investigation of magnetic property and defect formation energy in Ni-Mn-Ga ferromagnetic shape memory alloy

Microstructure and mechanical behaviors of Co-Ni Magneto - shape - memory alloys

Suppression of γ phase and its effect on mechanical behavior of melt-spun and annealed Ni–Mn–Ga high-temperature shape memory alloys

Formation of martensitic microstructure in epitaxial Ni-Mn-Ga films after fast cooling

Annealing Effects on the Structural and Magnetic Properties of Off-Stoichiometric Fe-Mn-Ga Ferromagnetic Shape Memory Alloys

Phase Transition of Ni 55− X Co X Mn 20 Ga 25 (8.5 ≤ X ≤ 11.0) Alloys with Different Compositions and Magnetic Fields

Phase transition of Ni55-xC0xMn20Ga25(8.5≤x≤11.0)alloys with different compositions and magnetic fields

Structure Dependence of Magnetic Properties for Annealed GaMnN Films Grown by MOCVD

Tuning Microstructure and Enhancing Mechanical Properties of Co-Ni-V-Al Medium Entropy Alloy Thin Films Via Deposition Power