Optimization of Mechanical Behavior of Steel and Concrete Continuous Composite Truss Girder Bridge

ZHANG Zhen-xue,NIE Jian-guo,TAO Mu-xuan,ZHU Li

2012-01-01

Abstract:To effectively improve the mechanical behavior of the hogging moment area of the steel and concrete continuous composite truss girder bridge,the Jizhao Bridge over Haihe Rive in Tianjin was cited as an example.The major design difficulties of the composite truss girder bridge were summarized and the conventional solutions to the difficulties were commented.Based on the summarization and comments,three measures of the partial composite technique,double composite techniques and optimized construction sequences were proposed for the optimal design of the Jizhao Bridge.The software MIDAS Civil was used to set up the finite element model for a side composite truss of the bridge,the whole construction process of the bridge was analyzed and the effectiveness of the three measures was checked.The results of comparative analysis reveal that the application of the three measures can keep the concrete deck slabs in compression all the time under the short-term combination of load effect and can make the maximum compressive stress in the steel plates of the lower chord reduced by about 25% as compared to the design scheme that the concrete is not cast.It is known herewith that the rational application of the measures can significantly reduce the tensile stress in the deck slabs and the compressive stress in the steel plates of the lower chord in the hogging moment area of the bridge,therefore can effectively avoid cracking in the slabs and improve the stability of the lower chord.