Abstract:This paper presented the optimal minimax and weighted least squares (WLS) methods for designing digital finite impulse response (FIR) filters to reduce the aliasing errors generated by the non-ideality of analog filters and mixers in bandwidth interleaving digital-to-analog converter (BI-DAC). To satisfy the given expected spurious free dynamic range (SFDR), we formulated these optimal designs of digital FIR filters in BI-DAC as a convex optimization problem-second-order cone programming (SOCP) that allowed the linear equality and convex quadratic inequality constraints including the magnitude flatness and the peak aliasing errors constraints to be merged. Furthermore, we derived the computational complexity of our presented optimal design. Several design examples were given to evaluate the performance of our presented unconstrained and constrained minimax and WLS designs using SOCP including their effectiveness and computational complexity. The simulation results showed that, in our presented unconstrained minimax and WLS designs using SOCP, the maximum distortion errors were all around 0.02 dB. The maximum aliasing errors were-73.9 and -80.5 dB, which satisfied the expected SFDR of a 12-bit BI-DAC system. In addition, we analyzed the influence of different values of the nonnegative weighting function on our presented unconstrained minimax and WLS designs using SOCP, and we found that there was a tradeoff among the nonnegative weighting function's value, and the distortion and aliasing errors. Moreover, when the constraints were imposed in our presented constrained minimax and WLS designs using SOCP in the selected frequency bands, the distortion errors were equal to zero and the aliasing errors were reduced below -110 dB, but the expense was that the larger distortion and aliasing errors achieved out of these selected frequency bands. Finally, we gave the computational complexity comparisons among our presented unconstrained and constrained minimax and WLS design using SOCP, we also compared the influence of the digital FIR filters' length on our presented designs' worst-case passband ripple and stopband roll-off, and we found that there was a tradeoff among the digital FIR filters' length, the passband ripple, the stopband roll-off, the computational complexity, and the actual hardware cost.

Optimal Algorithm for FIR Digital Filter with Canonical Signed Digit Coefficients

Decimation Filter Design in Sigma-delta ADC

The Design and Implementation of Fir Filter Based on Improved Da Algorithm

A novel design algorithm for low complexity sparse 2‐D FIR filters

Analysis of IIR digital filter's coefficient quantizations effect

A high-speed FIR digital filter with CSD coefficients implemented on FPGA

Design and implementation of an efficient FIR digital filter

Design of Square-root Raised Cosine FIR Digital Filters

Design and Implementation of Multiplierless FIR Filter Using COOT Bird Optimization Algorithm with Different Architectures*

Low Power Design For Fir Filter

Hybrid method for designing digital FIR filters based on fractional derivative constraints

A High-Speed, Programmable, CSD Coefficient FIR Filter

FIR digital filter redesign via sampled-data H∞ discretization in low-frequency domain

Higher order and optimized symmetric 2D FIR filter design and hardware architecture implementation using CSD-CSE

Design and implementation of an optimized FIR filter for IF GPS signal simulator

A hardware-effective digital decimation filter implementation for 24-bit ΔΣ ADC

Optimal Design of Multiplierless FIR Filter

A Novel Multiplierless Hardware Implementation Method for Adaptive Filter Coefficients.

Minimax and WLS Designs of Digital FIR Filters Using SOCP for Aliasing Errors Reduction in BI-DAC

Optimum Design of 2-D Lowpass FIR Filters for Image Processing Based on A New Algorithm

FIR Digital Filter Design by Sampled-Data H-infinity Discretization