Abstract:The hydrated morphology of anion-exchange membranes (used in alkaline membrane fuel cells) is a key aspect in determining their ion conductivity. Herein, we examine the changes in the morphology of hydrated polystyrene-b-poly(ethylene-co-butylene)-b-polystyrene functionalized with quaternary ammonium groups in the polystyrene phase. The effects of the degree of functionalization and styrene content were studied using dissipative particle dynamics simulations. The morphology was controlled by the following three factors: the hydration level, the degree of functionalization of styrene blocks, and the percentage of styrene in the block copolymers. Perfect lamellae, imperfect lamellae, disordered bicontinuous structures, gyroid-like structures, and the coexistence of layered structures and micelles were all observed under particular conditions. Among the three types, the imperfect lamella was made up of slices or subdomains of perfect lamella. These lamellae formed in different directions and were interconnected by the transitional regions. Pure water domains were formed at a high water content (λ ≡ nH2O/TMA+ ≥ 16), and the lowest degree of functionalization (25%) may require the highest hydration. An analysis of the clustering of water molecules revealed that a full percolating aqueous domain occurs when the hydration level reaches approximately λ = 12. Lowering of the functionalization and/or the styrene percentage was observed to postpone the formation of large connected water domains, but increasing the styrene percentage enables the percolation to occur at a lower water content.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.jpcc.0c03903?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.jpcc.0c03903</a>.Force field parameters, equivalent IEC and WU, atomic structures for different functionalizations, detailed views of morphologies, RDFs for certain beads, and total number of water beads in different systems (<a class="ext-link" href="/doi/suppl/10.1021/acs.jpcc.0c03903/suppl_file/jp0c03903_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Deuteration Impact on Micellization Pressure and Cloud Pressure of Polystyrene-block-polybutadiene and Polystyrene-block-polyisoprene in Compressible Propane

High-Pressure Micellar Solutions of Polystyrene-Block-Polybutadiene and Polystyrene-Block-Polyisoprene in Propane Exhibit Cloud-Pressure Reduction and Distinct Micellization End Points

High-Pressure Micellar Solutions of Symmetric and Asymmetric Styrene−Diene Diblocks in Compressible Near-Critical Solvents: Micellization Pressures and Cloud Pressures Respond but Micellar Cloud Pressures Insensitive to Copolymer Molecular Weight, Concentration, and Block Ratio Changes

Compatibilizing Efficiency of Copolymer Precursors for Immiscible Polymer Blends

Micellization Temperature and Pressure for Polystyrene-Block-Polyisoprene in Subcritical and Supercritical Propane

Effect of 1,4‐dioxane on Synthesis of Macroporous Poly(n‐isopropylacrylamide) Hydrogels

Simultaneous Interpenetrating Polymer Networks of Polyurethane from Pentaerythritol–Modified Castor Oil and Polystyrene: Structure–Property Relationships

Effects of Deuteration of a Polystyrene Chain on Its Thermodynamics and Hydrodynamics in Cyclohexane Around the Flory Θ-Temperature: the Static and Dynamic Laser Light Scattering Investigation

Synthesis of Isotactic Polystyrene in Hydrocarbons by Initiation with T-Buli in the Presence of Sodium Dodecylbenzenesulfonate

Effect of the Nature of Annealing Solvent on the Morphology of Diblock Copolymer Blend Thin Films

Control of Interaction Strength in Hydrogen-Bonded Polymer Blends Via the Density of the Hydroxyl Group

Thermodynamic Nature of Monodisperse Polystyrene in Mixed Solvent of Cyclohexane and Antisolvent Carbon Dioxide Using Synchrotron Small-Angle X-ray Scattering

Water Distributions In Polystyrene-Block-Poly[Styrene-G-Poly(Ethylene Oxide)] Block Grafted Copolymer System In Aqueous Solutions Revealed By Contrast Variation Small Angle Neutron Scattering Study

Controlling molar mass and dispersity in polymers through deuteration: the case of poly(phenyl D3-vinyl sulfide)

Deuteration‐Induced Superior Properties in Polymer/Soluble Acene Blends: A Comprehensive Study

Photocatalytic Multiple Deuteration of Polyethylene Glycol Derivatives using Deuterium Oxide

Effect of Polystyrene‐b‐poly(ethylene Oxide) on Self‐assembly of Polystyrene‐b‐poly(n‐isopropylacrylamide) in Aqueous Solution

Mesoscale Simulations of Quaternary Ammonium-Tethered Triblock Copolymers: Effects of the Degree of Functionalization and Styrene Content

Effect of Steric Hindrance on Microphase-separated Structures of Block Copolymers Constructed by Hydrogen Bonding

Influence of styrene-b-butadiene copolymer types on phase morphology and polymer partitioning between demixed-macrophases from HIPS-mimicking unstable blends

Microphase Separation and Morphology of the Real Polymer System by Dynamic Density Functional Theory, Based on the Equation of State