Abstract:Assorted morphologies of precipitates in fcc/bcc transformation systems have been reported, which often exhibit irrational characteristic. Various models have been developed to explain the habit plane (or the broad facet), but the overall morphologies of the precipitates are seldom explained quantitatively. In this work, the equilibrium cross-section of rod-shape austenite precipitates in duplex stainless steel is determined by atomistic simulation. The input orientation relationship (OR) between fcc and bcc phase is determined according to the O-line criterion (one of the interfaces contains a single set of dislocations), with the condition that the invariant line lies in close-packed plane pair of (1 (1) over bar(1) over bar)(f)|(10 (1) over bar)(b) and the Burgers vector of O-lines is [011](f|)/2|((1) over bar 11)(b)/2. The obtained OR is close to the K-S OR ((11 (1) over bar)(f)//(01 (1) over bar)(b), [101](f)//(111)(b)), with the deviation of 1.27 degrees from the parallelism in both planes and directions. Interfacial energy of interfaces in various orientations in the zone axis of the invariant line ([0.75 0.10 0.65](f)//[0.52 0.68 0.52](b)) has been calculated. To ensure the reliability of the calculated values, an initial atomic configuration free of interstitial and vacancy is constructed for each interface. The energies of the O-line interface, the interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) are found to have similar values, each at a local minimum. Based on the calculated interfacial energies, the equilibrium cross-section morphology is determined by the Wulff construction. The result shows that the morphology exhibits a near rhombus cross-section, which agrees consistently with experiments. One of the major facets is the O-line interface, normal to ((0.66) over bar 0.12 0.74)(f)//((0.51) over bar (0.24) over bar 0.83)(b), in agreement with the observation. The other facet is normal to Delta g((020)) (((0.25) over bar (0.87) over bar 0.42)(f)//(0.45 (0.73) over bar 0.51)(b)) in the calculated result, while it is normal to Delta g(((1) over bar 11)) (((0.36) over bar (0.77) over bar 0.53)(f)//(0.31 (0.71) over bar 0.63)(b)) in experimental results, with about 10 degrees difference between them. The discrepancy between calculated and observed results is probably because the experiments have not reached the equilibrium state. The dislocation structures in these three interfaces are identified from the atomic simulation results by a newly developed method based on the singular value decomposition of the Nye tensor. It confirms that the O-line interface contains a single set of [011](f)/2 dislocations with spacing of 1.5 nm. The interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) contains two sets of dislocations. The dislocation structure in the facet normal to Delta g((1) over bar 11)) is in good agreement with experimental observation of the non-O-line facet, including the local decomposition of dislocation core to (1 (1) over bar(1) over bar)(f) stacking faults.

Fractal structures of interface of zinc and cadmium metal leaves formed by electrodeposition

Fractal Structures Of Zinc Metal Leaves Grown By Electrodeposition

Fractal Growth of Quasi Two-Dimensional Copper Dendrites by Template-free Electrodeposition

Effect of Material Parameters on Dendritic Patterns of Ni-Cu Binary Alloy Using Phase-Field Simulation

Two-dimensional connective nanostructures of electrodeposited Zn on Au(111) induced by spinodal decomposition

Interface Fractal Construction In Ni/Kbr/Ni System

From Zinc Clusters to One-Dimensional Crystals on Quasi-Free Sustained Substrates

Long-range Ordering Effect in Electrodeposition of Zinc and Zinc Oxide.

Self‐organization of Periodically Structured Single‐crystalline Zinc Branches by Electrodeposition

An Investigation on the Equilibrium Morphology and Interfacial Structures of Pricipitates in Duplex Stainless Steel by Atomistic Simulation

Fractal growth of copper powder on point and plate electrodes based on diffusion-limited aggregation model

A Phase-Field Model of Dendrite Growth of Electrodeposited Zinc

Interface fractal construction in Ni{plus 45 degree rule}KBr{plus 45 degree rule}Ni system

Layouts of cadmium mixed gold nano clusters structure and the theoretical study of their electronic properties

Structures and Magic Numbers of Adatom Clusters on Metal Fcc (001) Surfaces

Atomic structure and energetics of amorphous–crystalline CuZr interfaces: a molecular dynamics study

Simulation for the Influence of Interface Thickness on the Dendritic Growth of NickelCopper Alloy by a Phase-Field Method

Computer Simulation on the Fractal Growth of Electrolytic Zinc

Density functional theory investigation on the stability, adhesion strength, tensile properties and fracture behavior of γ-Fe/Cu heterogeneous nucleation interface

Surface Structure and Stability of PdZn and PtZn Alloys: Density-functional Slab Model Studies

Experimental determination of solid-liquid interfacial free energy anisotropy in Al-Zn via equilibrium droplet method