Abstract:Introduction: This research has resulted in a system of sensors and software for effectively adjusting prosthetic alignment with digital numeric control. We called this suite of technologies the Prosthesis Smart Alignment Tool (ProSAT) system. Materials and methods: The ProSAT system has three components: a prosthesis-embedded sensor, an alignment tool, and an Internet-connected alignment expert system application that utilizes machine learning to analyze prosthetic alignment. All components communicate via Bluetooth. Together, they provide for numerically controlled prosthesis alignment adjustment. The ProSAT components help diagnose and guide the correction of very subtle, difficult-to-see imbalances in dynamic gait. The sensor has been cross-validated against kinetic measurement in a gait laboratory, and bench testing was performed to validate the performance of the tool while adjusting a prosthetic socket based on machine learning analyses from the software application. Results: The three-dimensional alignment of the prosthetic socket was measured pre- and postadjustment from two fiducial points marked on the anterior surface of the prosthetic socket. A coordinate measuring machine was used to derive an alignment angular offset from vertical for both conditions: pre- and postalignment conditions. Of interest is the difference in the angles between conditions. The ProSAT tool is only controlling the relative change made to the alignment, not an absolute position or orientation.Target alignments were calculated by the machine learning algorithm in the ProSAT software, based on input of kinetic data samples representing the precondition and where a real prosthetic misalignment condition was known a priori. Detected misalignments were converted by the software to a corrective adjustment in the prosthesis alignment being tested. We demonstrated that a user could successfully and quickly achieve target postalignment change within an average of 0.1°. Conclusions: The accuracy of a prototype ProSAT system has been validated for controlled alignment changes by a prosthetist. Refinement of the ergonomic form and technical function of the hardware and clinical usability of the mobile software application are currently being completed with benchtop experiments in advance of further human subject testing of alignment efficiency, accuracy, and user experience.

Optimal Design of Prosthetic Alignment Angle for Monolithic Prosthetics

Effect of Prosthetic Alignment on the Biomechanics of the Lower Extremity for Trans-Tibial Amputees

Design and Accuracy for POGO Stick with Three-Axis

Model-based biomechanical dental implant optimization in bone-implant system

Multi-objective design optimization of 3D micro-architected implants

Influence of the angle between tibial and prosthesis mechanical axes on tibial bone remodeling in total knee arthroplasty

Surrogate-based positioning optimization of hip prostheses for minimal stress shielding

Real-time optimization of prosthetic design for complete arch implant-supported treatments using finite element-based machine learning

Orientation Capability, Error Analysis, and Dimensional Optimization of Two Articulated Tool Heads with Parallel Kinematics

Modeling and simulation of muscle forces of trans-tibial amputee to study effect of prosthetic alignment.

Finite Element Analysis of Optimal Design of Distal Geometry of Cementless Femoral Prosthesis

Optimal intersurface stability for unicompartmental femoral component design with two pegs placed on the distal resection surface: 5 mm peg length increment and 10° peg inclination

Design and Optimization of Lower Limb Rehabilitation Exoskeleton with a Multiaxial Knee Joint

A Data-Driven Design Framework for Structural Optimization to Enhance Wearing Adaptability of Prosthetic Hands

The effects of trans-tibial prosthetic alignment on the activity of knee muscles

Numerical investigation of the relationship between pin deviations and joint coordinates of a unilateral external fixator

Enabling Technology for Remote Prosthetic Alignment Tuning

Biomechanical performance design of joint prosthesis for medical rehabilitation via generative structure optimization

Machine learning techniques for the optimization of joint replacements: Application to a short-stem hip implant

Effects of alignment on interface pressure for transtibial amputee during walking

[Rationale of kinematic alignment]