Accurate Analysis of Harmonic Gear Clearance and Visual Simulation

Jiao-long ZHANG,Jun ZHOU,Feng-qi ZHOU,Peng LIN
DOI: https://doi.org/10.3969/j.issn.1006-9348.2012.07.070
2012-01-01
Abstract:This paper focused on optimizing the harmonic drive.Aiming at the problem of the high complexity and low accuracy of calculation when the involute profile takes the place of the gear conjugate tooth profile,and in order to improve the accuracy and the convergence rate,this paper proposed the tooth crest interference inspection optimization algorithm to insure the gear teeth not only non-intervene but also transmit precisely.The minimum meshing clearance was established rapidly and accurately through the programming iterative calculation via graphical interface parametric design,and the meshing process was reproduced by the visual simulation.The simulation results show that the algorithm can obviously improve the accuracy and the convergence rate.Finally,through analyzing lots of cases,we identified the angle where the interference usually occurred,and used the deflection correction to correct the gear.The paper provides some references for gear machining and inspection.
What problem does this paper attempt to address?