Abstract:This work proposes and investigates a new multi-field-multi-constraint coupled topology optimization problem, in which stress control, design castability, and geometry dimensional shrinkage issues that are of concern to practical engineering are simultaneously considered. In the optimization proposal considered, a pair of special twin designs are generated using a two-projected-field scheme, which maintains a consistent topological configuration and uniform dimensional shrinkage variations during the optimization process. The implicit correlation between these twin designs poses major challenges to their independent stress and castability control. To this end, an appropriate formulation is presented by reasonably integrating stress and casting constraints into the optimization proposal with dimensional shrinkage. And, special numerical techniques including stress penalization, aggregation approximation, approximation correction, and regional regularization are appropriately introduced to construct an effective solution strategy. Typical numerical examples are operated to demonstrate the validity of the proposed method and systematically evaluate its numerical properties. The results indicate that in the absence of necessary stress control measures, the obtained twin designs cannot avoid local high-stress concentration under uniform dimensional shrinkage. In contrast, the proposed method can effectively address this issue, but at the cost of the design stiffness under a given material volume limit. As a result, twin designs used for blueprint and model designs that simultaneously meet stress, castability, and uniform dimensional shrinkage requirements are now readily available.

THE DESIGN OPTIMIZATION FOR THERMAL-STRESS COUPLED STRUCTURES BY CONSIDERING STRUCTURAL DESIGN VARIABLES AND MATERIAL DESIGN VARIABLES SIMULTANEOUSLY

Concurrent Topological Design of Composite Thermoelastic Macrostructure and Microstructure with Multi-Phase Material for Maximum Stiffness

MULTI-OBJECTIVE DESIGN OF THE MULTI-PHASE MICROSTRUCTURE FOR THERMAL CONDUCTIVITY OPTIMIZATION

Concurrent Design of Composite Macrostructure and Cellular Microstructure with Respect to Dynamic Stress Response under Random Excitations

Concurrent design of composite macrostructure and multi-phase material microstructure for minimum dynamic compliance

Two-scale Dynamic Optimal Design of Composite Structures in the Time Domain Using Equivalent Static Loads

Size-dependent Two-Scale Topological Design for Maximizing Structural Fundamental Eigenfrequency

Topology Optimization of Thermo-Elastic Structures with Multiple Materials under Mass Constraint

A Uniform Optimum Material Based Model For Concurrent Optimization Of Thermoelastic Structures And Materials

Topology Optimal Design of Material Microstructures Using Strain Energy-based Method

Structural Topology Optimization Considering Casting and Stress Constraints under Uniform Dimensional Shrinkage

Topology Optimization for Microstructures of Composite Materials Based on Thermal Conductivity

Topology Optimization Involving Thermo-Elastic Stress Loads

Topology Optimization of Material Nonlinear Continuum Structures under Stress Constraints

Continuum Structural Topological Optimization with Dynamic Stress Response Constraints

A homogeneous optimum material based model for concurrent optimization of thermoelastic structures and materials

Multi-scale Concurrent Material and Structural Design under Mechanical and Thermal Loads

DESIGN OPTIMIZATION FOR STRUCTURAL THERMAL BUCKLING

Size-dependent Optimal Microstructure Design Based on Couple-Stress Theory

Concurrent design of composite macrostructure and cellular microstructure under random excitations

Sensitivity And Optimization Of Transient Heat Transfer And Coupled Thermal Stress In Structures