[Determination of seven phenoxy acid herbicides in water by dispersive solid phase extraction-ultra performance liquid chromatography-tandem mass spectrometry based on cationic metal-organic framework mixed matrix membrane]
Xuefeng Ji,Shuang Li,Gege Wu,Lin Zhao,Jiping Ma
DOI: https://doi.org/10.3724/SP.J.1123.2021.01006
Abstract:Phenoxy acid herbicides are widely used because of their excellent efficiency and low cost. However, owing to their strong polarity and water solubility, these herbicides do not degrade easily in a water environment and persist for a long time in water bodies. These herbicides readily enter water bodies via surface runoff, infiltration, and other migration routes, thus affecting water quality safety. Therefore, it is of great significance to establish a sensitive and simple method for the quantitative analysis of phenoxy acid herbicides in environmental water. Given the low concentration of such contaminants in environmental water, appropriate detection methods are important. Ultra performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS) has high sensitivity and accuracy, thus being well suited for the phenoxy acid herbicides analysis. Sample preparation techniques are also important for the extraction and enrichment of contaminants in environmental water. Dispersive solid phase extraction (DSPE) has attracted considerable attention owing to its low cost, ease of operation, and low solvent consumption. In general, the selectivity and efficiency of solid phase extraction are largely dependent on the characteristics of the solid adsorbent materials. Ionic metal-organic frameworks (iMOFs) have excellent ion-exchange properties and show selective absorptivity to ionic compounds. In this work, a metal-organic framework (MOF) MIL-101-NH2 was synthesized by a facile hydrothermal method. Then, a cationic MOF mixed matrix membrane (MMM) was fabricated by soaking the MOFs in a polyvinylidene fluoride (PVDF) solution and further functionalization with quaternary amine groups. A method was developed for the determination of seven phenoxy acid herbicides in water by UPLC-MS/MS based on DSPE. The prepared material was characterized by Fourier transform infrared spectroscopy and scanning electron microscopy to determine its functional groups and morphology. The results showed that there were quaternary amine groups in the material, and that the functionalization did not have any obvious effect on the chemical and crystal structures of MIL-101-NH2. The prepared MIL-101-$NMe_{3}^{+}$-PVDF MMM was used as an adsorbent for DSPE to enrich the seven phenoxy acid herbicides in water. It is well known that the key factors influencing extraction efficiency are the adsorption and elution conditions. To establish the optimum extraction conditions, the influence of some important factors, including the adsorbent amount, sample pH, extraction time, elution solvent, elution volume, and elution time, was investigated in detail. Gradient elution was carried out with 0.01% formic acid aqueous solution and acetonitrile as the mobile phase. The target analytes were separated on an ACQUITY UPLC BEH C18 column (100 mm×2.1 mm, 1.7 μm), and multiple reaction monitoring (MRM) was conducted in the negative electrospray ionization mode. The external standard method was used for quantitative analysis. The established method was verified in terms of the linear ranges, limits of detection (LODs), limits of quantification (LOQs), recoveries, and precision. Under the optimal conditions, the seven phenoxy acid herbicides showed good linear relationships in their respective concentration ranges, and the correlation coefficients were all higher than 0.997. The LODs and LOQs were 0.00010-0.00090 μg/L and 0.00033-0.00300 μg/L, respectively. The recoveries were tested at three spiked levels of 0.005, 0.05, and 0.2 μg/L. The average recoveries of the seven compounds were in the range of 80% to 102%. The intra-day and inter-day relative standard deviations were within 1.4% to 9.4% and 4.2% to 12.6%, respectively. The established method was applied to the analysis of the phenoxy acid herbicides in tap water and reservoir water. Three levels of spiked samples were adopted to investigate the accuracy of the method. The results demonstrated that our method is applicable to the detection of trace phenoxy acid herbicides in water samples. In summary, this method has the advantages of simplicity, rapidity, and sensitivity, and it is suitable for the detection of the seven phenoxy acid herbicides in environmental water.