Abstract:A rapid and reliable quench detection is vital for high current superconducting magnet system to prevent irreversible damage to a magnet by the quench phenomenon. The method for detecting the occurrence of a resistive transition has been widely adopted in the superconducting magnet. In the case of the voltage monitoring by means of dedicated taps, the electron quench detection device (EQDD) conversion unit, which converts detected high voltages into voltage-drop signal, should be required in the superconducting high field magnet. The power source of traditional quench detecting system, which can monitor for superconducting magnet with middle power operation, is supplied through the power transformer since the transformer can provide galvanic isolation between circuits. On the other hand, in the case of the super high magnet systems such as Korea Superconducting Tokamak Advanced Research and International Thermonuclear experimental reactor, since the maximum operation current and voltage of the super high field magnet keep over 60 kA and 50 kV DC, a passive component, which has strong an isolation device and high dielectric resistor qualities, has been required in the super high field magnet. If the power transformer is adopted in the super high field magnet, it can cause high cost for volume capacity since it needs for higher dielectric resistance value over 500 MΩ. Authors proposed the wireless resonance antenna and multi-receiver coils which can keep high level of dielectric resistance value with stability. As well as, the wireless power charging unit can reduce system volume due to multi-charging receivers for one antenna. In this study, authors investigated the effect of inserted resonator (Sx) coil between antenna and receiver coils, as well as, evaluated the electric field and magnetic field among the resonance coils under 300 W 370 kHz RF power generator since the strong electro-magnetic fields by the resonance coils can affect the electron devices inside of the EQDD module.

THE QUENCH PROTECTION DEVICE OF SMES MAGNET

35 Kj/7 Kw Conduction-cooled High Tc Superconducting Magnet Energy Storage

Design and Experiments of Power Conditioning System for SMES

Apparatus and Experiment of High Temperature Superconducting Magnetic Energy Storage Used for Power System Stability Enhancement

Development of a Conduction-Cooled HTS SMES

Control Design of a Modular Current Source Power Conditioning System for High Temperature SMES

Commissioning, Performance, and Effect of the Quench Current-boosting Device on a Dedicated Superconducting Magnet

Design of control system for quench protection unit in CRAFT project

Protection Circuit and Quench Simulation of a 7 T Superconducting Magnet for Animal MRI

Optimized Design and Electromagnetic-Thermal- Mechanical Analysis of a Toroidal D-Shaped Superconducting Magnet in 5 MW LIQHY-SMES System

Design and Characteristic Analysis of Active Quench Protection System for Superconducting Magnet

A Novel PCS Control Strategy for SMES to Suppress Overvoltage of Magnet

Research on electromagnetic shielding device for pulse inductor in CRAFT quench protection system

A Multi-Module Current-Source Power Conditioning System (Pcs) For Smes To Improve Voltage Stability Of Microgrid

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

DESIGN OF THE MONITORING SYSTEM FOR SMES AND EXPERIMENTAL VALIDATION

Design and Improvement of Quench Protection for A 3 T MRI Superconducting Magnet

Practical Investigations of Wireless Multiple-Power Charging Unit for Electron Quench Detection Device in the Super High Field Superconducting Magnet

A surface-shunting method for the prevention of a fault-mode-induced quench in high-field no-insulation REBCO magnets

Energy Shift with Coupling (ESC): a new quench protection method

SMES BASED UNIFIED POWER QUALITY CONDITIONER AND CONTROL STRATEGY