Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

The Roles of Li+ and F− Ions in Li–F-codoped TiO2 System

Influence of Fe2o3 Doping on Morphology and Photocatalytic Activity of Tio2 Prepared by Adsorption Phase Synthesis

Visible-Light-Driven Titania/Silica Photocatalyst Co-Doped with Boron and Ferrum

F and Fe co-doped TiO<sub>2</sub> with enhanced visible light photocatalytic activity

F and Fe co-doped TiO 2 with enhanced visible light photocatalytic activity

Study on the Performance of F-Doped TiO_2

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Electronic and photocatalytic properties of N/F co-doped anatase TiO2

Characterization of LiF-doped TiO2 and its photocatalytic activity for decomposition of trichloromethane

Improvement Of The Photocatalytic Properties Of Tio2 By (Fe+Mo) Co-Doping-A Possible Way To Retard The Recombination Process

First-principles Study on the Electronic and Optical Properties of F- and Nb-doped Anatase TiO2

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

A F-Ion Assisted Preparation Route to Improve the Photodegradation Performance of A Tio2@Rgo System-How to Efficiently Utilize the Photogenerated Electrons in the Target Organic Pollutants

Investigation of Photocatalytic and Low-Emissivity Properties of TiO 2 :F Films Featuring Columnar Structure Prepared on SnO 2 :F Substrate by Sol–gel Method

Study on the mechanisms of photoinduced carriers separation and recombination for Fe3+–TiO2 photocatalysts

Structure influence of Fe3+ doped TiO2/SiO2 film on the photocatalytic properties

Effect of Fe doping on crystalline phase, structure and photocatalytic properties of TiO2 thin films

Synergistic Effect of V/N Codoping by Ion Implantation on the Electronic and Optical Properties of Tio2

Preparation, Characterization and Electronic Structures of Fe-doped TiO2 Nanostructured Fibers

Fluorine and phosphorus co-doped TiO2(001) nanosheets as a high-stability visible light-driven photocatalyst

Structure Influence of Fe~(3+)-TiO_(2)/SiO_(2) Film on the Photocatalytic Properties