Abstract:Below 1 K, the specific heat Cp of glasses depends approximately linearly on temperature T, in contrast with the cubic dependence observed in crystals, and which is well understood in terms of the Debye theory. That linear contribution has been ascribed to the existence of two-level systems as postulated by the Tunnelling Model. Therefore, a least-squares linear fit Cp = C_1 T + C_3 T^3 has been traditionally used to determine the specific-heat coefficients, though systematically providing calorimetric cubic coefficients exceeding the elastic coefficients obtained from sound-velocity measurements, that is C_3 > C_Debye. Nevertheless, Cp still deviates from the expected C_Debye proportional to T^3 dependence above 1 K, presenting a broad maximum in Cp/ T^3 which originates from the so-called boson peak, a maximum in the vibrational density of states g(f)/f^2 at frequencies around 1 THz. In this work, it is shown that the apparent contradiction between calorimetric and elastic Debye temperatures long observed in glasses is due to the neglect of the low-energy tail of the boson peak (which contribute as Cp proportional to T^5, following the Soft-Potential Model). If one hence makes a quadratic fit Cp = C_1 T + C_3 T^3 + C_5 T^5 in the physically-meaningful temperature range, an agreement C_3 = C_Debye is found within experimental error for several studied glasses.

Development of Modularized Design Software for Combination Tubes of Pressure Pipes

The Special Software Development of Combination Plumbing of Pressure Pipes in AutoCAD Using VB6.0

Object-oriented Visualization CAD System for DC Motor

The Experience of Second Developing AutoCAD and Illustration of Some Practical Programs

Rearch and Application of CAD System's Second-Development for Taper Roller Bearing

Research on Technologies and Methods of Intelligent Boiler CAD

Development of Fluid Machinery Multimedia Demonstration System Based on 3DS MAX and Authorware

Software System Design and Implementation Based on Principle of Modularized Serial Processing Model

Design of surface vessel EW simulating training system

Development of Carton Structural Design System Based on VBA

Development of Application Software of Open Numerical Control Shoe Last Machine Tool System

Study on Parametric Modeling of Axial Piston Pump Based on SolidWorks Secondary Development

Development of Integrated Design Software for Injection Machine Mould Board

Are the calorimetric and elastic Debye temperatures of glasses really different?

Modular technology of developing of the extensions of a CAD system. The axonometric piping diagrams. Common and special operations

Computer Aided System Development for Complex-shaped Part and Tool Design

THE STUDY AND APPLICATION OF AUTOMADESIGN SYSTEM OF THE BOLT AND MESH SUPPORT FOR TUNNEL

Mathematical and programming toolkit of the computer aided design of the axonometric piping diagrams

Process modularization with supporting software development of TS16949 quality control system

Software Design for Matching Analysis of Unit Module of Gas-Steam Combined Cycle

Development and Application of Chemical Engineering Design Software Based on AutoCAD2004