MATHEMATIC MODELING ON THERMAL RECOVERY OF NATURAL GAS HYDRATE

Tang Liangguang,Li Gang,Feng Ziping,Fan Shuanshi
DOI: https://doi.org/10.3321/j.issn:1000-0976.2006.10.033
2006-01-01
Abstract:It is regarded the decomposition process of gas hydrate under heat as essentially interface movement, i.e., hydrate reservoir could be divided into decomposition zone and hydrate zone during thermal recovery. Via proper simplification, heat transfer model of both zones are established and analytic solutions of the model are strictly derived. Through running the model for two different cases of recovering hydrate: by steam injection versus by hot water injection, it is established the rule of temperature field changed by the time of both decomposition zone and hydrate zone. Heat efficiency during hydrate thermal recovery, i.e., hydrate decomposition heat to total heat input ratio, has also been analyzed based on the model. Simulation shows under the same conditions that hot water injection produces higher heat efficiency than steam injection does. Heat efficiency of steam injection and hot water injection was 0.349 and 0.465 under the given condition. On the other hand, hydrate decomposition heat to total heat input ratio is closely related to hydrate formation properties such as hydrate saturation and decomposition zone heat transfer coefficient: the higher hydrate saturation is, the lower heat transfer coefficient is in decomposition zone, and the higher heat efficiency will be.
What problem does this paper attempt to address?