Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Condensation in the Continuum Regime

Condensational Growth and Evaporation in the Transition Regime

On the condensational growth of a multicomponent droplet

Analytical Methods to Calculate Condensation Rates of A Multicomponent Droplet

Condensation and evaporation of binary droplets with internal mass transfer

Molecular Dynamics–continuum Hybrid Simulation for Condensation of Gas Flow in a Microchannel

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Multiscale Dynamic Growth and Energy Transport of Droplets During Condensation.

Binary Droplet Evaporation in the Presence of an Inert Gas: an Exact Solution of the Maxwell-Stefan Equations

Vapor Condensation in Rayleigh–Bénard Convection

Condensation induced internal convection of two neighboring droplets

Characterization of Condensation on Nanostructured Surfaces and Associated Thermal Hydraulics Using a Thermal Lattice Boltzmann Method.

The enhancement effects of internal convection on the heat transport of condensing droplets out of pure steam and moist air

Interfacial cooling and heating, temperature discontinuity and inversion in evaporation and condensation

On the Early and Developed Stages of Surface Condensation: Competition Mechanism Between Interfacial and Condensate Bulk Thermal Resistances

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

On the Molecular Picture and Interfacial Temperature Discontinuity During Evaporation and Condensation

Numerical Analysis of Laminar Convective Condensation with the Presence of Noncondensable Gas Flowing Downward in a Vertical Channel

On temperature discontinuity at an evaporating water interface

Interfacial Wave Behavior and Its Effect on the Flow and Condensation Heat Transfer in a Microtube

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube