Abstract:Abstract Background: Recording of electrical activity of neurons is indispensable for decoding the information in the brain. The amplitude of signals recorded by electrodes is small, and it must be amplified to the level that can be digitalized by the analog-to-digital convert (ADC). A micro-power low-noise neural recording amplifier is indispensable for implant hippocampal cognitive prosthesis. When the process turns into deep submicron, the gate leakage current of the metal oxide semiconductor (MOS) transistor becomes larger and mismatch between devices becomes worsen. It is necessary to keep the neural amplifier robust in all process corners. Methods: The proposed circuit is a two-stage amplifier which can achieve a good trade-off between power consumption and noise. Four second-stage amplifiers share a common reference amplifier to reduce area and power consumption. A pseudo-resistor with high resistance is utilized to realize a very-low frequency high pass corner without external components. In order to minimize process variation, a bulk-compensated (BC) technique is adopted to maintain adequate tolerance in all corner case. Results: The 4-channel neural amplifier is designed and fabricated in a 40 nm standard complementary metal oxide semiconductor (CMOS) process. It achieves a mid-band gain of 54 dB, a bandwidth of 70 Hz to 7.7 kHz, a total input-referred noise of 3.2 μVrms , and a Noise Efficiency Factor (NEF) of 3.3 while consuming 4.68 µW from the 1.1 V supply. The core area of one channel is only 0.032 mm 2 . Conclusion: A 4-channel integrated neural recording amplifier chip with bias-compensated circuits is presented in this paper. Extensive simulations insure that the design is “center”. The chip layout is verified using design rules check (DRC) and layout versus schematic (LVS) design check with the help of verification tools. Test results shows that it is less sensitive to process variation and consumes less power compared with amplifier without bulk-compensated circuit. This makes the design robust and uniquely appropriate for low-power implant application.

A Transconductance Amplifier for Neural Signals Regeneration System

Design of a rail-to-rail operational amplifier for implantable neural signal regeneration systems

A Robust 4-channel Micro-power Low-noise Neural Recording Amplifier for Hippocampal Cognitive Prosthesis

A Low-Voltage Feed-forward Compensated Operational Transconductance Amplifier for Neural Signal Recording

Design of special microelectronic system chip for neural signal regeneration

Design of Readout Circuit Based on Probe Neural Biosensor

Rail-to-Rail Low Input Offset and High CMRR Transconductance Amplifier for Neural Signal Rebuilding Application

Function Electrical Stimulation Circuit for Neural Signal Regeneration System

Six-Channel Neural Signal Regeneration Integrated Circuit

Integrated circuit for single channel neural signal regeneration

IC for neural signal regeneration

Multi-Channel Neural Signal Regeneration IC

A Complementary Recycling Operational Transconductance Amplifier with Data-Driven Enhancement of Transconductance

A Single-Chip and Low-Power CMOS Amplifier for Neural Signal Detection

A High CMRR Instrumentation Amplifier Employing Pseudo-Differential Inverter for Neural Signal Sensing

CMOS Amplifier for Weak Neural Signal Detection

Novel design of a low power neural amplifier using split push pull balanced high swing OTA for brain machine interface

Low Noise Amplifier with Active Feedback Structure for Implantable Neural Recording.

Modeling and Designing of High-Gain, Wide-Band and Fast-Speed Operational Transconductance Amplifier

An Integrated Microelectrode Array System for Neural Signals Recording

A Design of CMOS Fully Differential Trans-independence Amplifier for Biological Signal Collection