Abstract:Gas metal arc welding (GMAW) of aluminum alloys has recently become popular in the auto industry to increase fuel efficiency of a vehicle. In many situations, the weld is short (say, less than two inches) and the “end effects” become very critical in determining the strength of the weld. At the beginning stage of the welding, when the metal is still “cold”, which is frequently called cold weld, limited weld penetration occurs. On the other hand, at the ending stage of the welding, a “crater” is formed involving micro-cracks and micro-pores. Both the cold weld and the crater can significantly decrease the strength of the weld and are more severe for aluminum alloys as compared to steels. Hence, there are strong needs to improve the GMAW process in order to reduce or eliminate the aforementioned end effects. In this paper, both mathematical modeling and experiments have been conducted to study the beginning stage, ending stage, as well as the quasi-steady-state stage of GMA welding of aluminum alloys. In the modeling, a three-dimensional model using the volume-of-fluid (VOF) method is employed to handle the free surfaces associated with the impingement of droplets into the weld pool and the weld pool dynamics. Transient weld pool shapes and the distributions of temperature and velocity in the weld pool are calculated. The predicted solidified weld bead shapes, including weld penetration and/or reinforcement, are in agreement with experimental results for welds in the aforementioned three stages. It was found that the thickness of the molten weld pool is smaller and there is no vortex developed, as compared to steel welding. The lack of penetration in cold weld is due to the lack of pre-heating by the welding arc. Three techniques are proposed and validated numerically to improve weld penetration by increasing the energy input at the beginning stage of the welding. The crater formation is caused by rapid solidification of the weld pool when the welding arc is terminated. By reducing welding current and reversing the welding direction before terminating the arc, the weld pool is maintained “hot” for a longer time allowing melt flow to fill-up the crater. This method is validated experimentally and numerically to be able to eliminate the formation of the crater and the associated micro-cracks.

Three-Dimensional Modeling Of Gas Metal Arc Welding Of Aluminum Alloys

Modeling Heat and Mass Transfer and Fluid Flow in Three-Dimensional Gas Metal Arc Welding

Numerical Modeling of Cold Weld Formation and Improvement in Gmaw of Aluminum Alloys

Three-Dimensional Modeling of Arc Plasma and Metal Transfer in Gas Metal Arc Welding

Modeling and Simulation of Laser Welding for Aluminium Alloy

Mathematical Modeling of Three-Dimensional Heat and Fluid Flow in a Moving Gas Metal Arc Weld Pool

An Improved Simulation Model for Three-Wire Gas Metal Arc Welding

A Comprehensive Model on the Transport Phenomena During Gas Metal Arc Welding Process

Modeling of Cold Metal Transfer Spot Welding of Aa6061-T6 Aluminum Alloy and Galvanized Mild Steel

Three-dimensional numerical simulation of arc and metal transport in arc welding based additive manufacturing

Temperature Simulation of Aluminium Alloy Double-Arc Welding Process on Simplified Conditions

Three-Dimensional Modeling of Grain Structure Evolution During Welding of an Aluminum Alloy

Investigation Of Transport Phenomena In Three-Dimensional Gas Metal Arc Welding Of Thick Metals

Modeling Three-Dimensional Plasma Arc in Gas Tungsten Arc Welding

Transport Phenomena and Their Effect on Weld Quality in GMA Welding of Aluminum Alloys

Numerical Modeling Of GMAW ARC

Three-Dimensional Modeling of the Plasma Arc in Arc Welding

Numerical Simulation of the Dynamic Behaviors of a Gas Tungsten Welding Arc for Joining Magnesium Alloy AZ61A

Physics-driven Modeling of Electron Beam Welding of Al-Cu Alloys from Molten Pool Flow, Microstructure to Mechanical Properties

3-D Numerical Simulation of Temperature Field in Moltenpool of Plasma Arc Welding

Three-Dimensional Modeling of Transport Phenomena and Their Effect on the Formation of Ripples in Gas Metal Arc Welding