Abstract:In this article, a tunable four-stage high-intermediate-frequency (IF) bandpass filter (BPF) chip using inductors with a $Q$ compensation digital resistor array (QCDRA) is presented. The high-IF BPF intends to filter out-of-band spurs and distortions for radio frequency analog-to-digital converter (RF-ADC) or RF digital-to-analog converter (RF-DAC), which leverages programmable $Q$ -enhanced inductors to achieve ultrawide programmable bandwidth. The fabricated filter center frequency can be programed from 1.3 to 1.7 GHz with a 50-MHz resolution, which also supports a tunable signal passband from 25 to 1000 MHz with 25-MHz frequency step, equivalent to a 1.5%–67% tunable fractional bandwidth when centering at 1.5 GHz. The BPF exhibits $<$ 50-ns signal bandwidth program settling time, suitable for agile radio applications. To ensure an accurate filtering, a three-point calibration scheme is proposed to auto-calibrate filter response due to temperature variations. The high-IF BPF chip is fabricated in a 65-nm bulk CMOS process with 80-mA current consumption, which achieves a 150.94-dB normalized dynamic range (DR). To the authors’ best knowledge, this high-IF BPF has demonstrated the widest fractional bandwidth programmability.

An IF Filter for GSM and WCDMA

A Highly Linear Lowpass Filter for GSM /WCDMA Receivers

A Highly Linear Filter and VGA with DC-Offset Correction for GSM/WCDMA Receivers

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A Baseband Lpf for Gsm, Td-Scdma and Wcdma Multi-Mode Transmitters

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Reconfigurable Low Pass Filter with Automatic Frequency Tuning for WCDMA and GSM Application.

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

A triple-mode ring dielectric resonator band-pass filter using substrate integrated waveguide (SIW)

A Reconfigurable Low Power Filter in 65 nm CMOS for Multi-standard Transmitters

Design of Rx Filter for WCDMA Direct-Conversion Front-End Using FBAR Technology

A Wide Tuning Range Low-Pass Gm-C Filter for Multi-Mode Wireless Receivers with Automatic Frequency Calibration

A 2.3mA 240-to-500MHz 6th-order active-RC low-pass filter for ultra-wideband transceiver

A multi-mode 1-V DAC+filter in 65-nm CMOS for reconfigurable (GSM, TD-SCDMA and WCDMA) transmitters

Design of Balanced RF Filter for Wireless Applications Using FBAR Technology

A Reconfigurable Analog Baseband Circuit for Wlan, Wcdma, and Bluetooth

A Multi-Mode DAC and Filter Block for Reconfigurable (GSM/TD-SCDMA/WCDMA) Transmitters

A Reconfigurable Baseband Circuit Applied for Wimax Low-If Receivers

An Image-Rejection Complex Filter with Low Power Based on Transconductance-Resistance-Capacitance Cells

A Cmos G(M)-C Complex Filter With A Reconfigurable Center And Cutoff Frequencies In Low-If Wimax Receivers

Design of a Low-Power CMOS Baseband Circuit for Wideband CDMA Testbed